User manual ACR ELECTRONICS RCL-75 SEARCHLIGHT

[. . . ] The sleek, robust design and modern construction materials of the searchlight body makes it attractive for recreational and commercial vessels. The searchlight is made of an UV resistant ASA plastic to resist yellowing, and is gasketed and finished to be resistant to the weather. The Searchlight Unit can be mounted where desired (see Figure 1 and Figure 2), using appropriate length 1/4" diameter, stainless steel fasteners. When mounting, be sure that the unit is able to rotate 361° without hitting any obstructions. [. . . ] (P/N 9427 - Figure 4) Caution - Be careful when using electrical power tools around water. 5. 3 Mounting the Remote Control Point PadTM The Point PadTM should be located within reach of the helm station. Flush mount and Surface mount. (see Figures 6 & 7) Both mounting options require access to the backside of the mounting location. (see Templates ­ Y1-03-0158-1) Make sure there are no obstructions behind the area where the switch is to be located. bulkheads, wires, plumbing, hardware. ) Check in advance to verify the wiring harness can be routed to this location. 5. 3. 1 Surface Preparation for Remote Control Point PadTM Make sure area is clean and dry. Verify that drill hole will not impact or harm other items (wires, plumbing, hardware bulkhead). 5. 4 Mounting the Light Remove deck mounting plate from light base (4 Allen bolts). Rotate the plate so that the arrows are pointing forward and the length of the arrow is aligned parallel to the keel. Mark the 4 mounting holes, starting with the one between the 2 arrows. D FIGURE 4 5. 4. 1 Surface Preparation for light Make sure surface is clean and dry. Verify that drill holes will not impact or harm other items (wires, plumbing, hardware or bulkheads). Can the backside of mounting surface be reached to install nuts and washers?Note: If the mounting surface is not flat, a special shapeable plate can be purchased, (P/N 9427), to adapt the light base to the surface. (see Figure 4) Drill 4 mounting holes (1/4") and a centered cable clearance hole (3/4"). Use caulk or bedding compound to seal bolt and wire holes before deck mount is attached to deck. The plates are keyed to each other and to the light, be sure the arrows are pointing in the correct direction. Use marine grade 316 stainless steel bolts, nuts, and lock washers to fasten the plate(s) to the mounting surface. Install and connect the control cable and (+) Red and (-) Black power leads. Leave at least 8" of wire coiled in the base of light to allow for servicing. Reinstall the four (4 ) stainless steel Allen bolts with the flat washer next to the plastic and the lock washer under the bolt head. D FIGURE 5 6. 0 OPERATION The remote control Point PadTM is simple to operate. [. . . ] will repair or, at its option, replace at no cost to you for labor, materials or return transportation, provided you obtain a Return Authorization from ACR Electronics, Inc. , 5757 Ravenswood Road, Ft. To obtain a Return Authorization, call our Customer Service Department at (800) 432-0227. This warranty does not apply if the product has been damaged by accident or misuse, or as a result of service or modification by other than the factory. Except as otherwise expressly stated in the previous paragraph, the COMPANY MAKES NO REPRESENTATION OR WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, AS TO MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR ANY OTHER MATTER WITH RESPECT TO THIS PRODUCT. [. . . ]