User manual ADS TECH MEDIACONVERTER QUICK GUIDE

[. . . ] Simple steps on how to configure your IP You can choose to use manual or automatic configuration. In Automatic mode, you must make sure that your net work is set to obtain IP automatically. Simple steps on how to setup your WIFI Make sure the following fields are exactly the same as the setting at your existing wireless network (setting at your Access Point). Fill in the fields listed in the Time Setup page and choose the time zone for your location. [. . . ] Select Check for firmware update link to load the latest firmware available for your unit. If your problem persists, contact with our Technical Support Department. Q1: Media-Link Device is not connecting to Media-Link Software Answer: Your Media-Link device can be connected to Media-Link Server PC via a home network using either a wired or wireless configuration. Firstly, go into the IP Configuration setup page : Press the Setup button on your Remote Control. Select IP Config using the Navigational buttons on your remote control, press Enter. Make sure that automatic configuration is selected if you have a DHCP server available in your home network. If not, please manually key-in the configuration according to your network environment settings. Q2: Media-Link Device still not connecting to Media-Link Software although the network settings are configured properly Answer: If you have a wired network configuration make sure that the LAN cable is firmly plugged into both your Media-Link device and the switch/hub you are using. Q3: Media-Link Device is not connecting to the internet Answer: Your Media-Link Device may be connected to the internet via your home network if you have a DSL or Broadband Internet connection. Your home network's connection to the internet If your Media-Link device is having trouble connecting to the internet, please check the following : Check the internet link is available Using your PC, try to navigate the Internet by accessing any website. Power-Cycle Network Devices If you have a wireless access point or a router, please reset it by turning off the power and turning it back on. Wait for a few minutes to allow these devices to complete it's startup. Check your network settings Verify that your Network Settings are correct. Complete the TCP IP settings on your DHCP server, if one is available. Else, ensure that the manually input IP address is correct to the corresponding server. Checking static IP address If you have assigned a static IP address for you Media-Link, make sure that the IP address is unique in your network and within the same network Class specifications. Which is to confirm the first 3 sets of the IP address in Media-Link are same as the other devices connected to your home network. For example, if your computer's IP address starts with "192. Q5: Media-Link is not connecting to my Wireless Network Answer: Checking the power on your access point Make sure that the wireless access point or wireless router in your home network is receiving power and that the "LINK/ ACT" light is ON. Check access point settings Maybe the channel settings and the encryption format doesn't tally with the ones set on your access point. [. . . ] Q5: Media-Link is not connecting to my Wireless Network Answer: Checking the power on your access point Make sure that the wireless access point or wireless router in your home network is receiving power and that the "LINK/ ACT" light is ON. Check access point settings Maybe the channel settings and the encryption format doesn't tally with the ones set on your access point. You can follow the instructions on these setups in Wifi Setup Page, Page 7. 11b wireless network standard and is currently not compatible with other wireless network standard such as 802. [. . . ]