User manual ART PROMIX

[. . . ] ART cessories March 2003 TM Creative audio solutions in cool little boxes. ProMIX Three Channel Microphone Mixer Problem: You need to add 3 mics to a mixer, which only has one available channel. [. . . ] c. ) If any mics require phantom power, set the appropriate Phantom DIP switches to the on position (down). d. ) To avoid picking up unwanted low-frequency noise (rumble, thumps, etc. ), it is advisable to roll off the low frequency response of mics other than those specifically for bass drum, bass guitar amp, upright bass or keyboard amps. e. ) Connect the balanced XLR (male) Output to the mic input on the mixer with a low-impedance mic cable. Alternatively this jack can be connected to the unbalanced input of an amplifier, another mixer, etc. h. ) Adjust the Level controls for the desired mix and check the Clip LED to make sure one or more of them are not turned up too far. A small amount of Clip LED activity on occasional peaks is acceptable as it fires 3dB below the onset of actual clipping distortion. [. . . ] Otherwise, make sure there are two 9V batteries connected inside the battery compartment. 90 DAY WARRANTY DESIGNED & DISTRIBUTED BY: APPLIED RESEARCH AND TECHNOLOGY · 215 Tremont Street · Rochester, New York 14608 · USA For Customer Service, please call: 585. 436. 2720 · Email: cserve@artproaudio. com · www. artproaudio. com · ART-ARTcs-03/03 [. . . ]