User manual AXIS 25205

[. . . ] Close the housing with the two clips on the side. Routing the cables 1. Route the cables (network and power) to the location where the bracket arm is to be installed. Note: The cables can either be routed through the bracket arm (recommended) or through a hole in the base of the bracket. This hole needs to be drilled in the recess area where the casing metal is thinner to accommodate easy drilling. Determine the size of the hole to accommodate the fitment of the cable gland (not supplied). [. . . ] Position the swivel (11) on the end of the bracket arm (12) with the two cables coming through the open slot. Ensure that the swivel is positioned with F (front) at the front and R (rear) at the back. Now position the widget (10) inside the swivel (11) with the cables coming through the opening. Match the F and R on the widget with the F and R on the swivel, assuring that F remains at the front and R at the back. Line up the positioning bolt (13) with the screw hole in the widget (10) and tighten it using the large allen key (1). Position the white rubber seal (9) on the flat face of the swivel (11) by pushing the power cable Power through the off centre hole on the left and the network cable through the off centre hole on the right. The two off centre holes should be positioned towards the back. Network Two off centre holes positioned at the back 9 9. Position the housing (8) on the swivel (11) with the white rubber seal (9) in-between, the CAT. 5 cable going through the larger hole in the black board and the power cable going through the smaller hole. Attach the housing to the swivel by tightening up the four screws held in the swivel. Use the small allen key (2) to do this. 290B Outdoor housing Connecting the camera Warning: Be sure to work inside the housing in dry conditions. Rain water, moisture and prolonged condensation inside the housing may cause serious damage to the camera and disturb the picture quality when in operation. Always ensure that the power is disconnected before starting any work or opening the housing. 1. The minimum cable conductor area for installation of the housing is 0. 5mm2. Warning: Regulations relating to other parts of the system may require a bigger conductor area. You are responsible that the requirements of these regulations are met. 3. Wire the power cables into the terminal block, the cable with the "+" sign must be wired as shown (+) Caution: Ensure that all wires are correctly and securely wired into the terminal block. Tighten the cable tie so that the power cable is held firmly. (+) Wiring diagram 290B 4. All models - attach an RJ45 connector (not supplied) to the network cable allowing sufficient cable to reach the back of the camera. Once you have fitted the connector, plug it into the network connector at the back of the camera. AXIS 2420 using a Coaxial cable - attach an RG59 BNC plug to the coaxial cable. Once you have fitted the BNC plug to the cable connect it to the video output at the back of the camera. Important: Only a 90° BNC angle plug will fit inside the housing. [. . . ] Worn or damaged seals should be replaced. Recommendation: Treat all visible seals with silicone at least once a year to prevent them from drying out and to aid opening and closing of the housing. Use an all-purpose silicone spray for use on electrical equipment and components, and also compatible with rubber, metal and plastic materials. Clean the housing with a damp cloth only (not on the window). Do not use chemicals to clean the housing as this may affect the powder coat finish. Burnt fuses in the fused terminal block can be replaced to reinstate the power supply of the camera. [. . . ]