User manual DREMEL 2000 VERSATIP

[. . . ] Do not use the tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating tools may result in serious personal injury. [. . . ] Make sure the gas you are using is refined butane gas that can also be used in lighters. Then fill the tank with liquid butane gas observing the instructions on the butane gas container. The tank is full when liquid butane gas escapes through the filling valve. This mechanism requires two handed operation to protect against (accidental) ignition by children. When the Dremel Versatip is cold, ignition might cause a short whistling sound. This is normal and does not mean there is something wrong with the tool. * Note: the flame guard must be installed correctly, for the tool to be able to ignite. When the ignition switch is released, the flow of gas is automatically shut off, causing the Dremel Versatip to stop and slowly cool down. to continuously operate the Dremel Versatip , follow the steps in figures 2 , 3 and 4. To switch the Dremel Versatip off, let go of the ignition switch and move the lock button to the right (figure 5). USING WITH AN OPEN FLAME To use the Dremel Versatip with an open flame, unscrew the flame guard, remove the catalyst (and tip if attached) and screw flame guard back onto the tool and securely tighten the flame guard nut. FLAME LENGTH AND TEMPERATURE ADJUSTMENT After ignition, make sure the tool is on by checking that the catalyst starts to glow. [. . . ] After soldering or in case of excess solder on the tip, wipe it on the sponge when it is still hot. This DREMEL product is guaranteed in accordance with statutory/country specific regulations; damage due to normal wear and tear, overload or improper handling will be excluded from the guarantee. [. . . ]