User manual DREMEL 395

[. . . ] Connect units that are used outdoors by means of a fault current protection switch (FI) with a maximum triggering current of 30 mA. Dremel is able to ensure flawless functioning of the unit only if the original accessories intended for it are used. Do not change nozzles while glue gun is in "on" position, plugged in, or warm to the touch. [. . . ] Do not change nozzles while glue gun is in "on" position, plugged in, or warm to the touch. Before changing nozzles, make sure glue gun is cool to the touch, unplugged, and the switch is in the "off" position. The glue gun is intended for the quick gluing of clean, dry and grease-free materials with glue heated to its melting point. The unit, accessories and packaging should be sorted for environment-friendly recycling. According to the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into national right, power tools that are no longer usable must be collected separately and disposed of in an environmentally correct manner. Description Model number Rated power Heating up Maintaining heat Heating time Glue temperature low (LO) Glue temperature high (HI) Gluing capacity Glue stick Ø Weight approx. Use completely unrolled and safe extension cords with a capacity of at least 5 Amps. To turn the light off, slide the switch (1) to the "Off" position. PREPARATIONS FOR GLUING The surfaces to be glued must be clean, dry and free of grease. The ambient temperature and the work piece to be glued must not be colder than +5 °C or warmer than +50 °C. Do not allow the hot glue to come into contact with persons or animals. If hot glue touches the skin, immediately hold the spot for some minutes under a stream of cold water. NOTE: For your first use, you may need to load up to two full glue sticks before glue begins to flow. Always keep the unit clean so that it functions properly and accurately. [. . . ] If hot glue touches the skin, immediately hold the spot for some minutes under a stream of cold water. NOTE: For your first use, you may need to load up to two full glue sticks before glue begins to flow. Always keep the unit clean so that it functions properly and accurately. [. . . ]