User manual DREMEL 754

[. . . ] There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. [. . . ] If you find yourself forcing the rotary tool forward to cut instead of just guiding it through the cut, chances are the blade is dull or coated with wood pitch. When cleaning gum and wood pitch from blade, unplug the rotary tool and remove the blade. wipe the blade with kerosene or similar solvent to remove the gum and pitch. A dull or damaged blade slows the speed of cutting and places a heavier load on your rotary tool, and can cause KICKBACK. Keep extra blades on hand so you always have sharp, efficient blades ready to replace a dull or damaged one. In case of a complaint, send the tool undismantled together with proof of purchase to your dealer. Regulations; damage due to normal wear and tear, overload or improper handling will be excluded from the guarantee. According the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into national right, power tools that are no longer usable must be collected separately and disposed of in an environmentally correct manner. For more information on the Dremel assortment, support and hotline, go to www. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. Pushing the guard foot up on the attachment, place the blade onto the mandrel arbor, making sure the arrows on the blade are facing out and the blade is resting flat on the shoulder of the mandrel arbor. Make sure the blade teeth point in the same direction as arrows on upper guard. While retracting the lower guard, check operation and condition, including the spring. Have your power tool serviced by a qualified repair person using only identical replacement parts. Your rotary tool should be running at the set speed before starting the cut, and turned off only after completing the cut. dIRECTIONAL GUIDE Feed direction for the rotary tool is right to left only. For a straight 90° cut, use the directional guide on the left side of the guard to lumber to verify line of cut. Causing an uncontrolled saw to lift up and out of the workpiece toward the operator. Blade stalls and the motor reaction drives the unit rapidly back toward the operator. Edge of the blade can dig into the top surface of the wood causing the blade to climb out of the kerf and jump back towards operator. Always be sure that hands or fingers do not interfere with the free movement of the lower guard. [. . . ] Trigger and hold the saw motionless in the material until the blade comes to a complete stop; never attempt to remove the saw from the work or pull the saw backwards while the blade is in motion or kickback may occur. And check that saw teeth are not engaged into the material (if saw blade is binding, it may walk up or kickback from the workpiece as the saw is restarted). (unsharpened or improperly set blades produce narrow kerf causing excessive friction , blade binding and kickback). When cutting across the grain, the fibers of the wood have a tendency to tear and lift. [. . . ]