User manual FIESTA A24027 SPACEMAKER ASSEMBLY

[. . . ] Hazardous Fire or Explosion may result if these instructions are ignored. It is your responsibility to see that your new barbeque is assembled, installed, maintained and cared for properly. [. . . ] Attach (2) casting supports to rear legs ONLY using (2) 1 1/2" bolts and nuts. 2 Position remaining left front leg through console slot and insert leg cap. 4 Position left leg on bottom pan and loosely assemble with 1 1/2" bolt, washer and nut. 5 Loosely assemble left leg to console with casting Insert push button ignitor and snap into place. Carefully insert and snap ignitor electrode into ignitor clip as shown. Ensure end of ignitor electrode and wire fit down through hole in casting, and electrode does not get damaged. Also ensure burner legs fit into casting slots and that venturi tube is centered over valve orifice by 10mm. Position cover and secure from rear with spring clip in groove on right hinge pin. Install front handle as shown using #10 x 3" bolts, plastic spacer, heat gasket and wing nuts. WARNING: Before proceeding with the following steps, ensure you have read: · Hose and Regulator Sections of the USE AND CARE INSTRUCTIONS located at the front of this manual. Gas cylinder, if supplied with your grill, has been shipped empty for safety reasons. Before attaching hose/regulator to tank, be sure cylinder valve and appliance valves are OFF. [. . . ] Failure to follow those instructions may result in a hazardous fire or explosion causing serious bodily injury and/or property damage. How to Order Spare Parts: When ordering, always give the following information: 1. [. . . ]