User manual FUTABA 14MZ AIRCRAFT QUICK GUIDE

[. . . ] 2) Initially choose "NO" when asked whether you wish to transmit. 3) Select the Linkage Menu by holding the linkage menu button until it beeps or by pressing on the wrench/screw driver icon. [. . . ] Select the Linkage Menu by holding the linkage menu button until it beeps. Select the Frequency icon again to finish setup the frequency or you can just press on the frequency display with your stylus. a) If the Receiver ID is not correct, enter your receiver ID number and press enter with your stylus. c) Fully extend your transmitter antenna and select "YES" in the check change?7) Select the Linkage Menu by holding the linkage menu button until it beeps or by pressing on the wrench/screw driver icon. 8) On the Model Select screen, press on the Rename icon to rename your model. After you input the name of the model, press return to go back to the Model Select screen. 9) Press on the upper left Model Select icon with your stylus to return to the linkage menu. 10) To place the servos in the traditional Futaba slots (1=aileron, 2=elevator, 3=throttle, 4=rudder), Select the Function icon and this will show you all of your functions and their current locations. For traditional setup, select Elevator next to CH 1, this will take you to the Function page, select Aileron to turn slot 1 of your receiver into the aileron channel. Note that more than one slot in your receiver can perform the same function at any time. [. . . ] For more advanced programming, please refer to your owner's manual. We sincerely hope you enjoy your new Futaba 14MZ radio system. FUTZ8651 for FUTJ9400, FUTJ9407, FUTJ9410 [. . . ]