User manual HARMAN KARDON AVR 320

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual HARMAN KARDON AVR 320. We hope that this HARMAN KARDON AVR 320 user guide will be useful to you.


HARMAN KARDON AVR 320 : Download the complete user guide (1075 Ko)

You may also download the following manuals related to this product:

   HARMAN KARDON AVR 320 Product Information (228 ko)

Manual abstract: user guide HARMAN KARDON AVR 320

Detailed instructions for use are in the User's Guide.

[. . . ] AVR 320 Audio/Video Receiver OWNER'S MANUAL ® ® Power for the Digital Revolution. ® AVR 320 Audio/Video Receiver 3 4 4 5 8 10 12 15 16 18 18 19 20 20 22 23 24 25 26 26 28 28 28 29 31 32 32 32 33 34 34 34 34 36 37 37 37 37 37 38 38 39 40 40 41 42 44 54 54 55 Introduction Safety Information Unpacking Front Panel Controls Front Panel Information Display Rear Panel Connections Main Remote Control Functions Zone II Remote Control Functions Installation and Connections System Configuration Speaker Placement System Setup Input Setup Surround Setup Speaker Setup Delay Settings Output Level Adjustment Manual Output Level Adjustment Operation Surround Mode Chart Basic Operation Source Selection Surround Mode Selection Digital Audio Playback Tuner Operation Tape Recording Front Panel Input/Output Connections Output Level Trim Adjustment 6/8-Channel Direct Input Advanced Features Display Brightness Turn-On Volume Level Semi-OSD Settings Multiroom Operation Programming the Remote Direct Code Entry Auto Search Method Code Readout Learning Codes Erasing Learned Codes Macro Programming Programmed Device Functions Volume Punch-Through Channel Control Punch-Through Reassigning Device Control Selectors Function List Setup Code Tables Troubleshooting Guide Processor Reset Technical Specifications Typographical Conventions In order to help you use this manual with the remote control, front panel controls and rear panel connections, certain conventions have been used. EXAMPLE ­ (bold type) indicates a specific remote control or front panel button, or rear panel connection jack EXAMPLE ­ (OCR type) indicates a message that is visible on-screen or on the front panel information display 1 ­ (number in a square) indicates a specific front panel control ¡ ­ (number in a circle) indicates a rear panel connection a ­ (number in an oval) indicates a button or indicator on the remote A ­ (letter in a square) indicates an indicator in the front panel display å ­ (letter in an oval) indicates a button on the Zone II remote 2 TABLE OF CONTENTS Introduction Thank you for choosing Harman Kardon!With the purchase of a Harman Kardon AVR 320 you are about to begin many years of listening enjoyment. Designed to provide all the excitement and detail of movie soundtracks and every nuance of musical selections, the AVR 320 is truly a multichannel receiver for the new millenium. [. . . ] For example, if the front left and front right speakers are each 10 feet from the listening position and the center-channel speaker is 8 feet away, the delay is figured as 10­8=2, suggesting an optimal center delay of 2 milliseconds. To set the delay time for a specific input, the DELAY ADJUST menu (Figure 6) should be visible on your on-screen display. If the system is not already at that point, press the OSD Button v to bring up the MASTER MENU, press the > Button n three times or until the on-screen > cursor is pointing at the DELAY ADJUST line. Press the Set Button p to call up the menu. 23 SYSTEM CONFIGURATION System Configuration Before beginning the output level adjustment process, make certain that all speaker connections have been properly made. The system volume should be set to the level that you will use during a typical listening session. Finally, make certain that the Balance Control Ò is set to the center "12 o'clock" position. Using EzSet Harman Kardon's exclusive EzSet remote makes it possible to quickly and accurately set the AVR 320's output levels without the use of a sound pressure meter, although manual adjustment is also available. However, for the easiest set-up, follow these steps while seated in the listening position that will be used most often: 1. Make certain that all speaker positions have been properly configured for their "large" or "small" settings (as outlined above) and turn off the OSD system if it is in use. Adjust the volume so that it is at -15, as shown in the on-screen display or Main Information Display Y. Hold the remote in front of you at arm's length, being sure not to cover the EzSet Sensor Microphone 44 at the top of the remote. Release it when the Program/SPL Indicator c stops flashing and and remains lit. Within five seconds, press the "5" Numeric Key r on the remote if your system is configured for 5. 1 operation with standard speakers or the "7" Numeric Key r on the remote if your system is configured for 6. 1/7. 1 operation with a full speaker complement including rear surround speakers. Once the correct channel configuration button has been pressed the test noise will be heard from the front left speaker. At this point, EzSet will take over, adjusting the output level of each channel so that when the process is complete all levels will be equal and at the set reference point. This process may take a few minutes, depending on the extent of adjustment required. During the adjustment, you will see the location of the channel position being adjusted appear in the on-screen display (if connected) in the Main Information Display Y, alternating with a readout of the output setting, relative to the reference volume level, and in the Speaker/Channel Input Indicators Q where the letters for the channel being adjusted will flash to indicate from which channel the test tone should be heard. As the adjustment proceeds, a few things will happen simultaneously: · The channel position being adjusted will flash in the Speaker/Channel Input Indicators Q. If the test noise is heard from a channel other than the one shown in the Indicator, there is an error in the speaker connections. If this is the case, press the Test Button i TWICE to stop the adjustment. Then, turn the unit off and verify that all speakers are connected to the proper Outputs nop and that any connections made to rear surround speakers powered by optional amplifiers through the Preamp Outputs 38 are correct. · As the individual channels are set, the channel name and the adjustment offset will appear in the on-screen display (if connected) and the Main Information Display Y. [. . . ] Select Learn Sleep Test SPL Volume Up Night Multiroom Volume Down Channel/Guide / AVR Function Power On Power Off Mute AVR Select DVD Input Select CD Input Select Tape Input Select Video 1 Select Video 2 Select Video 3 Select Video 4 Select Tuner Select 6/8 Ch. Input Select Sleep Test Tone Volume Up DVD Power On Power Off Mute DVD Select CD/CD-R Power On Power Off Mute Tape Power On Power Off Mute VCR (VID1) Power On Power Off Mute TV (VID1) Power On Power Off Mute CBL (VID3) Power On Power Off Mute SAT (VID3) Power On Power Off Mute CD Select Tape Select VCR Select TV Select VID3 Select Channel + TV/DVD Input Select Input Level Up CDR Select TV/VCR Volume Up Channel ­ TV/VCR Volume Up Channel + TV/Cable Volume Up Channel ­ Channel + TV/Sat Volume Up Channel ­ Surround Select Surround Mode Select Multiroom Select Volume Down Channel Trim Move/Adjust Up Speaker Adjust Move/Adjust Left Set Digital Input Select Move/Adjust Down Delay Adjust Title Up Menu Left Enter Right Open/Close Down Return 1 2 3 4 5 6 7 8 Tuner Mode Chapter 9 0 Audio Tune Up Direct Tuner Entry Angle Night Mode Select Subtitle On/Off CDR Select Input Level Down Up Intro Scan Menu Left Enter Right Exit Down Open/Close 1 2 3 4 5 6 7 8 Repeat 9 0 Time Cancel Sleep FAV FAV Random Play 9 0 9 0 9 0 9 0 1 2 3 4 5 6 7 8 Volume Down Up Menu Left Enter Right Exit Down Prev Channel 1 2 3 4 5 6 7 8 Volume Down Volume Down Info/Guide Up Menu Left Enter Right Exit Down Prev Channel 1 2 3 4 5 6 7 8 Info/Guide Up Menu Left Enter Right Exit Down Prev Channel 1 2 3 4 5 6 7 8 Speaker/Menu fi Set fl Digital/Exit ¤ Delay/Prev. 1 2 3 4 5 6 7 8 Tun-M 9 0 Memory Tune Up Direct Next Chapter Track Direct 42 FUNCTION LIST Function List (continued) No. Button Name 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 Clear Preset Up Tune Down OSD D. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HARMAN KARDON AVR 320




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual HARMAN KARDON AVR 320 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.