User manual HARMAN KARDON HK3350

[. . . ] While sophisticated systems are hard at work within the HK3350 to make all of this happen, hookup and operation are simple. Color-keyed connections and a comprehensive remote control make the HK3350 easy to use. To obtain maximum enjoyment from your new receiver, we urge you to take a few minutes to read through this manual. This will ensure that connections to speakers, source playback units and other external devices are made properly. [. . . ] Connect the output of a second audio recorder, CDR, MD or other line-level audio device to the Tape 2 Play jacks A. If a recorder is used, connect its Rec/In jacks to the matching Tape 2 Record outputs B. The audio output of any electronics product with a line-level output, such as a TV set, satellite receiver or DVD, may be connected to the Aux jacks 7. Connect the outputs of a turntable with a moving magnet cartridge to the Phono inputs 5. To insure that the phono playback is noisefree, connect the ground wire from the tone-arm to the Phono Ground terminal 2. When connecting wires to the speakers, be certain to observe proper polarity. Remember to connect the "negative" or "black" wire to the same terminal on the receiver and the speaker. Similarly, the "positive" or "red" wire should be connected to the like terminals on the HK3350 and speaker. We also recommend that the length of cable used to connect speaker pairs be identical. For example, use the same length piece of cable to connect the Speaker 1 left and right or Speaker 2 left and right speakers, even if the speakers are a different distance from the HK3350. NOTE: While most speaker manufacturers adhere to an industry convention of using black terminals for negative and red ones for positive, some manufacturers may vary from this configuration. Keep the jumpers in a safe place should they be needed at a later time. Using high-quality audio interconnect cables, connect the Preamp Out jacks E to the input jacks on your power amplifier. Make certain to match the right output to the right input and the left output to the left input. Note that when an external power amplifier is used, no special adjustments are required. All volume and other control adjustments are made using the standard front panel or remote controls. If you wish to use external processing equipment, such as an equalizer, you may connect the device to the preamp-out and main-in jacks by removing the Preamp-Out/Main-In Jumper Pins D and connecting the Preamp Out E jacks to the inputs of the external device, and the outputs of the device to the Main In C jacks. Alternatively, you may connect the external device to the Tape Monitor Loop. Connect the Tape Monitor Record/Out jacks 9 to the inputs of the external device, and connect the outputs of the device to the Tape Monitor Play/In jacks 8. AC Power Connections This unit is equipped with an accessory AC outlet. It may be used to power accessory devices, but it should not be used with high-current draw equipment such as power amplifiers. This Switched AC Outlet I will receive power only when the unit is on. [. . . ] Step 4: The LED Indicator will remain on for one second, and then blink three times to indicate that it has reset the group of keys for the selected device page. Resetting the Entire Remote It is also possible to completely reset all of the programmed codes in the remote to the factory default settings. Use the following procedure: Step 1: Enter the learning mode by simultaneously pressing any of the Device buttons ç and the Learn button . Step 2: Press and release any device button other than PHONO, AM or FM. [. . . ]