User manual HOTPOINT HNP 9.5 CM X

[. . . ] €¢ It is not intended for use by children or persons with sensory or mental disability and lack of experience or familiarity, except under the supervision or instruction of a person responsible for their safety. €¢ Never operate the unit without its grease filter installed!€¢ NEVER use the hood as a support, unless expressly instructed to do so. €¢ The room must be adequately ventilated if the hood is used at the same time with other equipment burning gas or other fuels. [. . . ] Using a smaller diameter tube and exhaust hole reduces the extraction capacity of the hood and also increases its running noise. Do not connect the hood to flues carrying combustion fumes from other equipment (boilers, chimneys, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. Of exhaust tube (cm) 15/12 15/12 15/12 Bulb draw (W) Total draw (W) Halogen 2 x 25 160 Bulb (V) Bulb draw (W) Total draw (W) Halogen 2 x 25 195 Model code HNP 6. 6 CM (OW)/HA Bulb (V) Bulb draw (W) Total draw (W) Filter or ducted?If you wish to use it as a filter unit, you must install the proper ACCESSORY KIT. Note: If supplied with the hood, the accessory active charcoal filter unit may already be installed. Instructions for transforming the hood from the ducted to the filter version are given in this manual (see “Filter version”). 8 CM (AN)/HA Bulb (V) Halogen Bulb draw (W) Total draw (W) 2 x 25 300 17 GB The hoods are conforming to the following EC Directives: • “Low voltage” Directive 2006/95/EC (12-12-2006) • “EMC” Directive 2004/108/EC (15-12-2004) Models with soft button keypad HNP 9. 5S CM (AN)/HA T1 T2 T3 T4 T5 T6 T1 Motor reset Pressing the button while the hood is in operation turns it OFF. After 5 minutes, the hood returns to the previous speed; pressing a speed button (T2, T3 or T4) quits booster mode and sets the selected speed. T6 Lights ON/OFF T1 T2 T3 T4 T5 T1 Motor reset Pressing the button while the hood is in operation turns it OFF. T5 Lights ON/OFF Grease/odour filter warnings The T2 icon flashes to indicate that the grease filter is saturated, while T3 flashes to indicate that the odour filter is saturated, and if both are flashing then both filters are saturated. You must then clean/replace the grease filter (A) or odour filter (B) or both, accordingly (see “Maintenance and care”). To reset the filter counter: Hold down T4 for three seconds while the hood is on. [. . . ] The filter saturates after a variable time, depending on the type of cooking and how often the grease filter is cleaned. This filter can NOT be washed or regenerated Disassembly: Rotate the filter 90° to remove it from the suction assembly. Assembly: Fit the active-carbon filter into the suction assembly and rotate it 90° to secure it in place. Replacing the bulbs Disconnect the unit from the mains and remove the grease filter. [. . . ]