User manual JBL HTI6
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JBL HTI6. We hope that this JBL HTI6 user guide will be useful to you.
Manual abstract: user guide JBL HTI6
Detailed instructions for use are in the User's Guide.
[. . . ] Logo to be attached to grille depending on vertical or horizontal installation.
HTI6C
Template/paint shield (punch out at perforation).
One pair of speakers with grilles.
Template/paint shield (punch out at perforation).
2
SPEAKER PLACEMENT
FRONT SPEAKERS (HTI6, HTI8, HTI55) English
400 600
MODELS HTI6, HTI8 AND HTI55 AS REAR SPEAKERS
5 6 ft.
WALL
WALL
WALL
WALL
MODEL HTI6C IN CEILING
be placed at about the same height from the floor as the listeners' ears will be, with the tweeters aimed toward the listening position at ear-level height. Model HTI55 is suitable for the front left, center and right positions, and it may also be used as a side surround or surround back speaker. [. . . ] Greater than 30 ft.
16 gauge 12 gauge 10 gauge
INSTALLATION
The JBL HTI Series in-wall speakers were designed to be easily installed. However, if you are unsure of your ability to properly install these loudspeakers, please contact your dealer or a qualified installer.
Tools Needed
Pencil
Phillips #2 screwdriver
Measuring tape
Utility knife
Carpenter's level
Awl
4
EXISTING CONSTRUCTION
HTI6, HTI8, HTI55
Level
1/2" 1/2" 1/2"
Template
Remove the grille from the speaker frame by pulling on the paper tab. If the tab is missing, to avoid scratching the grille or baffle you may unfold a paper clip, insert the straight end through one of the holes in the grille, and gently pull up.
Determine the correct speaker location. Note: Remove the inner template, which is the paint shield, at the perforation. Although the HTI55 may be oriented either horizontally or vertically, the installation procedure is the same.
Note: Always allow at least one-half inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.
Cut the drywall.
Connect the speaker wires to the speaker.
Place the frame assembly in the wall.
Screw down each of the four (six for HTI55) Phillips head screws. The locking tabs will swivel into place and secure the unit to the rear surface of the drywall.
The HTI speakers feature unique swivel mounts for the tweeters that enable you to aim the very directional high frequencies toward the listening position, at ear-level height. Before installing the speaker grille, gently press on the outer edge of the tweeter mount to adjust the position of the tweeter. The tweeter will not swivel more than 15 degrees in any direction; do not attempt to force it to move further. You may also rotate the tweeter to orient the JBL logo as desired.
Replace the metal grille. For the HTI55 only, attach the JBL logo to the grille to correspond to vertical or horizontal installation.
5
English
EXISTING CONSTRUCTION
English HTI6C
1/2" 1/2" 1/2"
Remove the grille from the speaker frame by pulling on the paper tab. If the tab is missing, to avoid scratching the grille or baffle you may unfold a paper clip, insert the straight end through one of the holes in the grille, and gently pull up.
Determine the correct speaker location. Note: Remove the inner template, which is the paint shield, at the perforation. Note: Always allow at least one-half inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.
Connect the speaker wires to the speaker.
Place the frame assembly in the wall.
The HTI speakers feature unique swivel mounts for the tweeters that enable you to aim the very directional high frequencies toward the listening position, at ear-level height. Before installing the speaker grille, gently press on the outer edge of the tweeter mount to adjust the position of the tweeter. [. . . ] · Check all wires and connections between receiver/amplifier and speakers. Make sure none of the speaker wires are frayed, cut or punctured.
7
SPECIFICATIONS
HTI6 English
Frequency Response
HTI8
Frequency Response
HTI55
Frequency Response
HTI6C
Frequency Response
38Hz 20kHz (10dB)
Recommended Maximum Amplifier Power
30Hz 20kHz (10dB)
Recommended Maximum Amplifier Power
40Hz 20kHz (10dB)
Recommended Maximum Amplifier Power
40Hz 20kHz (10dB)
Recommended Maximum Amplifier Power
100 watts
Impedance
120 watts
Impedance
120 watts
Impedance
100 watts
Impedance
8 ohms nominal
Sensitivity
8 ohms nominal
Sensitivity
8 ohms nominal
Sensitivity
8 ohms nominal
Sensitivity
88dB (2. 83V/1m)
Crossover Frequency
90dB (2. 83V/1m)
Crossover Frequency
88dB (2. 83V/1m)
Crossover Frequency
88dB (2. 83V/1m)
Crossover Frequency
2, 500Hz
Woofer
2, 500Hz
Woofer
2, 000Hz
Woofer
2, 000Hz
Woofer
6-1/2" Polymer-coated aluminum cone w/rubber surround
Tweeter
8" Polymer-coated aluminum cone w/rubber surround
Tweeter
Dual 5" polymer-coated aluminum cone w/rubber surround
Tweeter
6-1/2" Polymer-coated aluminum cone w/rubber surround
Tweeter
1" Pure-titanium dome, w/Elliptical Oblate SpheroidalTM (EOS) waveguide, and swivel mount
Plate Size (W x H)
1" Pure-titanium dome, w/Elliptical Oblate SpheroidalTM (EOS) waveguide, and swivel mount
Plate Size (W x H)
1" Pure-titanium dome, w/Elliptical Oblate SpheroidalTM (EOS) waveguide, and swivel mount
Plate Size
1" Pure-titanium dome, w/swivel mount
Plate Size (Diameter)
233mm (9-3/16")
Mounting Cutout Size (Diameter)
216 x 279mm (8-1/2" x 11")
Mounting Cutout Size (W x H)
257 x 333mm (10-1/8" x 13-1/8")
Mounting Cutout Size (W x H)
391 x 191mm (15-3/8" x 7-1/2")
Mounting Cutout Size
181 x 246mm (7-1/8" x 9-11/16")
Mounting Depth
225 x 300mm (8-7/8" x 11-13/16")
Mounting Depth
56 x 152mm (14" x 6"3)
Mounting Depth
200mm (7-7/8")
Mounting Depth
98mm (3-7/8")
Weight per Speaker
102mm (4")
Weight per Speaker
98mm (3-7/8")
Weight per Speaker
108mm (4-1/4")
Weight per Speaker
5kg (11 lb)
6. 1kg (13. 5 lb)
2. 6kg (5. 7 lb)
4. 5kg (10 lb)
All features and specifications are subject to change without notice. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JBL HTI6
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JBL HTI6 will begin.