User manual JUNO JDS5320B

[. . . ] Dieses Gerät entspricht den EWGNormen CE 87/308 überFunkentstörung. Electrolux - Hausgeräte GmbH -Zentraler Ersatzteildienst ELPRO electro-service GmbH Marienhütte 12 57080 Siegen Dunstabzüge (0271) 319361/62 Bei Ersatzteilbestellellung bitte unbedingt Geräte-ldent-Nr. Sie finden diese Angaben auf dem Typenschild (nach Abnahme des Fettfilterhalters sichtbar). Durch genaue Angaben helfen Sie uns, Ihren Auftrag schnellstmöglich zu erledigen. [. . . ] Choosing the exhausting pipe The coupling ring B has a diameter of 120mm. According to your installation the pipe can be directed either towards the ceiling or towards the walls (fig. Using the multi-connector C, Ø100, Ø110 and Ø125 mm exhausting pipes can be used. Ø 120 mm exhausting pipe: the multiconnector has not to be fitted. Ø 125 mm exhausting pipe: insert the multi-connector on the coupling ring and remove, using a proper tool, the upper unused Ø 100 and Ø 110 mm rings of the multi-connector. Ø 110 mm exhausting pipe: same procedure, but removing the Ø 100 mm ring only. Ø 100 mm exhausting pipe: apply the multi-connector on the coupling ring. Suggestions for the installation and use of the hood -- The horizontal sections of the pipe must be slanted slightly upwards (about 10%) to ensure an easy flow of the air outwards. -- The best performance of the unit is obtained in the external exhaust model (suction), therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. 4 m) and with few curves. Installation The hood must be installed at least 65 cm from the hob of electric cookers and at least 75 cm from the hob in the case of gas or mixed cookers. Fixing the front panel Take off the door H (fig. Apply the scheme N3 on the rear side of the front panel, considering that the arrow indicates the upper side (fig. 8). Warning! -- If the hood is run at the same time as a burner or fireplace that depend on ambient air (for example gas, Diesel, coal or wood heaters, water heaters, etc. ) be careful, because the hood, when it exhausts the air, removes the ambient air required by the burner or fireplace for combustion. -- For secure operation and to prevent discharged gas from coming back in, the vacuum must not exceed 0, 04 mbr. This may be done by making sure the air inlet into the room passes through nonclosing openings such as air recycling wall boxes, doors, windows or with other technical measures. The use of an unprotected flame is dangerous for the filters and could cause fires. Electric connection Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. [. . . ] It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. The hood doesn't light-ON if the flap is not mounted Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Changing the bulbs -- Disconnect the hood from the electricity. [. . . ]