User manual JUNO JKG8493

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Manufacturers' storage recommendations should be strictly adhered to. During normal operation, the condenser and compressor at the back of the appliance heat up considerably. [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. 14 Instructions for total built-in Door reversibility (Fig. 1 Right opening Remove the pins «P» and «P1». Remove «P1» from the right side. Building-in instructions Housing dimensions Height Depth Width 1780 mm 550 mm 560 mm For safety reasons, minimum ventilation must be as shown in Fig. 2: Attention: keep ventilation openings clear of obstruction. 50-min. cm 2 200 D027 15 Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 Press in the joint covers between the appliance and the kitchen furniture. Fig. 6 A D023 D098 If after having carried out the operation described in section 3 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 7 A B D339 D265 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. 5 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 H 20m m D D094 D092 C 16 Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 PR35 In case of side fixing of the appliance, it will be sufficient to loose the screws fixing the bracket (G) and to position it as shown in Fig. 11 G G D321 17 OPERATION The freezer compartment of this model is of the «frost-free» type. This means that no frosting occurs on the inner walls of the compartment or on food during operation. The absence of frosting is achieved by constant circulation of cold air inside the compartment, produced by an automatic fan blower. Fresh food refrigeration To obtain the best performance, do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. To help you use your refrigerator correctly, here are some more useful hints: Raw meat (beef, pork, lamb & wild fowl): wrap in polythene bags and place on top of the salad crisper and, for safety, only store in this way for one or two days at the most. [. . . ] 14 D037 20 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Replacing the interior light bulb The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not go on when the door is open, check that it is screwed into place properly. 15 Periodical cleaning Never use metal objects for cleaning your appliance as it may get damaged. [. . . ]