User manual JUNO SSI0360S

[. . . ] This appliance is designed for storing - If the power cord is damaged, it must be food, domestic use and being used replaced by a certified service agent or according to these instructions only. Specialised companies that are If the power plug socket is loose, qualified to do so by the do not insert the power plug. Manufacturer must carry out service and repairs including - There is a risk of electric shock or repairing and changing the power fire. Accessory parts supplied by Without the lamp cover of interior them should be used only for lighting you must not operate the repairing. [. . . ] Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. Theappliance shall not be discarded together with the urban refuse and rubbish. Information on your local disposal sites may be obtained from your municipal authorities. Remove the plug and ensure that any locks or catches are removed, to prevent young children being trapped inside. Wait 4 hours before connecting the appliance to allow the oil to flow back in the compressor. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. The temperature regulator allows you to adjust the temperature inside the refrigerator according to use and external conditions. The following effects are of significance in respect of the interior temperature: ambient temperature quantity and temperature of the food stored; frequency with which the door is opened and how long it is left open the location of the appliance. Insert the plug into the wall socket and turn the thermostat knob clockwise beyond position< O > (OFF). At this type of appliance defrosting cooling compartment is automatic without any external intervention. The thermostatic control interrupts the operation of compressor at regular intervals for more or less time - during this cooling is interrupted - temperature of the cooling compartment increases and defrosting occurs. after defrosting the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet into the evaporative tray maintained on the top of compressor and evaporates due to warmth of it. Check and clean the outlet of melting water coming during Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The most typical case of clogging up in the defrost water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of cooling compartment and freezes to it. If you remove the food right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful - because of the above - when placing foods wrapped in paper into the appliance. During heatwaves, the refrigerator temporarily happens to operate constantly - during this the automatic defrosting is ineffective. Remaining small ice and frost stains on back plate of the cooling compartment after defrosting period is not abnormal. It is recommended to wash the inside of the refrigerator in 3-4 weeks time. [. . . ] The cause could be the introduction of large quantities of food and/or frequent opening/closing of the door. Temperature control may cause clicking Noises sounds when the system is connected ordisconnected. The injected cooling gas may produce a gurgling soundwhile passing through the tubes. The insulation material used has a tendency to slighly increase noise levels, how ever it allows for much better insulation and a lower energy consumption. [. . . ]