User manual LIFT-MASTER 940D

[. . . ] Operation: Opener activates when 4-digit password and Enter button is pressed. If wrong numbers are accidentally pressed, correction can be made immediately. The Keypad will blink for 15 seconds after the password is transmitted. [. . . ] Continue holding the ENTER and LIGHT buttons while you press the push bar on the Multi-Function Door Control (all three buttons are held). Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad. If light bulbs are not installed, two clicks will be heard. LOCK LIGHT LOCK LIGHT Side two contains instructions for installing the Keyless Entry, changing the personal entry password and setting a temporary password. 1 INSTALLATION Keyless Typical TO CHANGE AN EXISTING, KNOWN PIN If the existing PIN is known, it may be changed by one person without using a ladder. Press the four buttons for the present PIN, then press and hold the # button. The door should move. Entry Installation Choose a convenient location for installation. Exterior Front Wall It should be at eye 1-Piece or level, reachable by the Sectional Door shortest person who will Door Jamb Edge use it, and within sight (Optional) of the door. Door Jamb Face For a one-piece door, (SECTIONAL DOOR ONLY) choose the optional KEYLESS ENTRY MUST BE location shown in the INSTALLED WITHIN illustration to avoid SIGHT OF THE DOOR injury as the door swings up and out. Test the reception of the Keyless Entry by operating your opener from the selected location. Remove the battery compartment Bottom cover to access the bottom mounting hole mounting hole: · Insert a small phillips screw driver Battery into the small hole at the bottom of Battery the cover and gently pull outward to Cover loosen. Mark 4-1/4" (10. 6 cm) up the centerline from the bottom and drill a 1/8" pilot hole. Install top mounting screw, allowing 1/8" (3 mm) to protrude above surface. With cover open so bottom mounting hole is visible, use a punch to mark hole. Replace keypad and complete installation with bottom screw, using care to avoid cracking plastic housing. To replace the battery cover, insert the lip at the top and snap in place. TO SET A TEMPORARY PIN You may authorize access by visitors or service people with a temporary 4-digit PIN. [. . . ] SPECIAL NOTE: The temporary password can ONLY be programmed to keypads working on a Chamberlain, Craftsman® or LiftMaster Garage Door Opener. It WILL NOT work on keypads programmed to an external receiver. THE KEYLESS ENTRY BATTERY WARNING To prevent possible SERIOUS INJURY or DEATH: · NEVER allow small children near batteries. Dispose of old batteries properly. WARNING CAUTION WARNING The temporary password will continue to CLOSE the door even after the time has expired. [. . . ]