User manual MARANTZ VP12S1
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MARANTZ VP12S1. We hope that this MARANTZ VP12S1 user guide will be useful to you.
Manual abstract: user guide MARANTZ VP12S1
Detailed instructions for use are in the User's Guide.
[. . . ] R
Model VP-12S1 User Guide DLPTM Projector
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
The lightning symbol in the triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation mark in the triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND. For the customers in the USA:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] REMOTE switch (EXTERNAL/INTERNAL)
When using this projector independently, set this switch to "INTERNAL". When using this projector in a system with a Marantz DVD player or AV Receiver equipped with a remote sensor, set the switch to "EXTERNAL".
n AUX OPTICAL
Connect the optical input from an audio equipment. Audio out terminal of DV-IN signal.
/0 TRIG. 1(TRIGGER 1)
When the unit is turned on, 12V is output. This allows such as a powered up/down screen, whenever the projector is turned on or off.
3
ENGLISH
/1 TRIG. 2(TRIGGER 2)
Select ON or OFF at each aspect mode, such as Full, Normal, Zoom, and Through to control screen aspect ratio with powered up/down dual aspect ratio screen. Note: Do not use TRIG. 1 and TRIG. 2, as the power source.
ENGLISH
/2 LIGHT ON/OFF
Select ON : The connector panel lights up.
/3 RS232C
Connect the RS232C of equipment for external control.
/4 AC IN
Connect the supplied AC power code.
/5 Lamp cover /6 Lamp cover securing screw /7 Ventilation holes
Notes: · Do not place anything near the ventilation holes to avoid overheat inside the unit. · Do not place your hand or objects near the ventilation holes; the air is coming out.
4
INTRODUCTION
Bottom
ENGLISH
w
q
q
q Adjustment lever
Lift the projector and turn the adjustment lever right or left. Then, release the lever, the adjustable feet is locked.
w Ventilation holes
Notes: · Do not place anything near the ventilation holes to avoid overheat inside the unit. · Do not place your hand or objects near the ventilation holes; the air is coming out.
Height Adjustment
How to use adjustable feet and adjustment lever.
(1) Release the adjustable feet.
(2) Detail adjustment
PRESS DOWN UP DOWN
Note : Lift the unit up carefully.
5
Remote Controller
ENGLISH
l RGB key
Select the RGB IN signal.
¡0 THEATER key
Select the Theater picture mode. When the key is pressed, the mode toggles Theater1, Theater2, Theater3 and Theater Default.
s
a d
¡1 STANDARD key
Select the STANDARD picture mode. When the key is pressed, the mode toggles Standard1, Standard 2, Standard 3, and Standard Default.
¡2 DYNAMIC key
Select the Dynamic picture mode. When the key is pressed, the mode toggles Dynamic1, Dynamic2, Dynamic3 and Dynamic Default. Note : If you need discrete command for above picture modes, you can down load from "www. marantz. com".
h j k ¡0 ¡3 ¡4 ¡9 ¡8 TM0
PROJECTOR
f l g ¡2 ¡5 ¡7 TM1 ¡1 ¡4
¡3 INFO key
Turn the information menu on or off.
¡4 CINEMA key
Press to turn the CINEMA mode auto 3-2 pull down mode on or off.
¡5 NORMAL key
Select NORMAL mode from four aspect ratio modes.
¡6 FULL key
Select FULL mode from four aspect ratio modes.
¡7 ZOOM key
Select ZOOM mode from four aspect ratio modes.
¡8 THROUGH key
Select THROUGH mode from four aspect ratio modes.
a POWER ON key
Turn the projector on.
¡9 AUX key
Select the AUX IN (DV IN) signal.
s STANDBY key
Turn the projector off.
TM0 FOCUS key
Display a focus pattern.
d 3 / 4 / 1 / 2 keys
Control the MENU cursor.
TM1 V-MUTE key
Cuts off the picture.
f ENTER key
Confirm "Reset All", "Reset Lamp Life", "New Lamp?".
g MENU key
Display the on-screen menu.
h COMPONENT key
Select the COMPONENT VIDEO IN signal.
j S-VIDEO key
Select the S-VIDEO IN signal.
k VIDEO key
Select the VIDEO IN signal.
6
INTRODUCTION
Preparing the Remote Controller
1. Open the cover.
CAUTION The available battery types are limited: manganese dry cell and alkaline dry cell. Never throw batteries in a fire or attempt to open up its outer casing. If the user does not intend to use the Remote Controller for a long time, remove the batteries. The Remote Controller operation may not function if the projector's IR sensors are exposed to direct sun light or strong artificial light, or if there is an obstacle between the IR sensors and the Remote Controller.
2. Insert batteries (AA).
Make sure to match the + and marks on the batteries with inside the battery compartment.
3. Close the cover.
7
ENGLISH
INSTALLATION
Recommended Setting
7 Table Top
Throw distance
CAUTION For ceiling installation, consult with Marantz authorized dealer. It could damage your eyesight.
VP-12S1
ENGLISH
Side view
Adjust the vertical and horizontal positions of the projector.
Horizontal center of the screen
Flat view
7 Ceiling Installation
Ceiling
Note : Lens shift position is at Full up.
8
SET UP PROCEDURES
Distance between the projector and the screen (throw distance)
ENGLISH
Screen size (Diagonal) Screen
VP-12S1
Throw distance
16:9 screen Screen Size (Diagonal) Minimum Throw distance Maximum Minimum
4:3 screen Throw distance Maximum
40 inch
50
7/16
inch
58
11/16
inch
46
1/4
inch
53 3/4 inch 1, 365 mm 81 9/16 inch 2, 071 mm 109 5/16 inch 2, 777 mm 137 1/8 inch 3, 483 mm 164 15/16 inch 4, 190 mm 206 5/8 inch 5, 249 mm 276 3/16 inch 7, 014 mm 345 11/16 inch 8, 780 mm
17/8
1, 281 mm 60 inch 76 9/16 inch 1, 945 mm 102 3/4 inch 80 inch 2, 609 mm 128 100 inch
7/8
1, 491 mm 89 inch 2, 260 mm 119 1/4 inch 3, 029 mm 149
9/16
1, 172 mm 70 1/8 inch 1, 782 mm 94 3/16 inch 2, 392 mm 118
3/16
inch
inch
inch
3, 273 mm 155 inch
3, 798 mm 179
13/16
3, 001 mm 142
3/16
inch
inch
120 inch
3, 938 mm 194 1/4 inch
4, 568 mm 225 1/4 inch 5, 721 mm 300 15/16 inch 7, 644 mm 376
11/16
3, 611 mm 178 3/16 inch 4, 526 mm 238 3/16 inch 6, 050 mm 298
1/4
150 inch
4, 934 mm 259 5/8 inch
200 inch
6, 594 mm 325 inch
inch
inch
250 inch
8, 255 mm
15/16
9, 567 mm
17/8
7, 575 mm
13/16
Minimum = x Screen size Maximum = 11/2 x Screen size 17/8 Unit : inch Minimum = 33. 21 x Screen size 47. 6 Maximum = 38. 46 x Screen size 47. 6 Unit : mm Note : Tolerance ±5 %
Minimum = x Screen size Maximum = 13/8 x Screen size 17/8 Unit : inch Minimum = 30. 49 x Screen size 47. 6 Maximum = 35. 31 x Screen size 47. 6 Unit : mm
9
Image Position Adjustment
ENGLISH
You can adjust the image position with the Lens Shift knob.
7 Turn the Lens Shift knob to clockwise :
The image goes up. · Maximum range to throw up : Bottom of the image correspond to the center of the Projection Lens.
Clockwise
Up
7 Turn the Lens Shift knob to counterclockwise :
The image goes down. · Maximum range to throw down : Top of the image correspond to the center of the Projection Lens. Counterclockwise
Down
10
SET UP PROCEDURES
Advanced Setting
When the projecting image is a trapezoid, correct it in Keystone-V and/or Keystone-H in the Display Menu.
Picture Adjust Setting Display Config Trigger 2 Memory
Keystone V Keystone H Auto Adjust Picture Shift V Size V Picture Shift H Size H Phase
50 50 50 50 50 50 50
7 Keystone-V(Electronic vertical keystone correction)
7 Keystone-H(Electronic horizontal keystone correction)
Note : Electronic horizontal keystone correction works properly when the lens shift position is at Full Up.
11
ENGLISH
The Screen Images in a Wide screen (16:9)
ENGLISH
· Press the ZOOM key, the NORMAL key or the FULL key on the remote controller for the 4:3 aspect ratio video source. [. . . ] Waverley, VIC 3149, Australia Taborstraße 95 / Ladestraße 1, Gebäude Hangartner, A-1200 Wien, Austria P. O. Box 237, 141, Government Avenue, Manama, Bahrein 1078, Ramjoy Mohanja Lane Asadgonj, Chittagong 4000, Bangladesh Brusselbaan 278, 9320 Erembodegem, Belgium Makedonia Blvd. 16, 1606 Sofia, Bulgaria 633 Granite Court, Pickering, Ontario No. 38 Yushan Road, ShiQiao, Pan Yu, Guang Dong, China P. O. Box 5604, Nicosia, Cyprus Sokolska 41, 67902 Rajecko, OKR, Blansko, Czech Republic Dali Allé 1, 9610 Noerager, Denmark P. O. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MARANTZ VP12S1
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MARANTZ VP12S1 will begin.