User manual MARSHALL AMPLIFIER ACOUSTIC AS100D SOLOIST

[. . . ] Introduction The AS100D is a comprehensively featured 100 Watt combo amplifier, specially designed for use with a variety of acoustic instruments. Between its four channels, this combo has the flexibility to handle instruments with piezo transducers or magnetic pick-ups, plus microphones for both vocal and instrument reproduction. Its 2 x 50 Watt stereo configuration gives you enough power to perform on stage with superb clarity, while the provision of a balanced line out allows direct connection to an external PA system for larger concert venues. English The built-in digital effects add an entirely new dimension to the range of sounds available. [. . . ] Please ensure the amplifier is switched off and unplugged from the mains electricity supply before being moved. 14. Phase Switch Reverses the phase of the signal to cut out unwanted resonances caused by the instrument and speakers being in phase. This can considerably reduce the amount of low frequency acoustic feedback. Ensure that you test this in the position where you will actually perform. 23. External Effects Switch Activates the external effects loop for the acoustic instrument channels. Channel 3 - Microphone 24. Microphone Input XLR type socket to take the input from an external microphone for either vocal or instrument reproduction. 15. Phase Switch Reverses the phase of the signal to cut out unwanted resonances caused by the instrument and speakers being in phase. Ensure that you test this in the position where you will actually perform. Rear Panel Features 1. Mains Input Your amp is provided with a detachable mains (power) lead that is connected here. The specific mains input voltage rating that your amplifier has been built for is clearly marked on the back panel. Before connecting for the first time, please ensure that your amplifier is compatible with your electricity supply. Too much bass can cause unwanted feedback, therefore care should be taken when setting this control. The best position to start is 12 o'clock, then adjust from there as desired. 4. Effects Level Control Rotary control to adjust the external effects return level. 5. Stereo Effects Return Left / Mono and Right returns to accept the output from an external effects processor. If the processor is mono (such as a floor pedal), connect to the Left / Mono return jack. 26. Phantom Switch If you require phantom power for your condenser microphone, pressing this switch provides +15V. 17. Treble Control Adjusts the high end or treble frequencies in your tone. Again, care should be taken when setting this control as too much treble will cause high pitched feedback. The starting point of the 12 o'clock position is best, then adjust from there to suit your own preference. 27. Footswitch Jack Socket For connection to the supplied remote footswitch which provides switching of both internal and external effects. 6. Outputs Left and Right direct outputs, fully balanced for connection to an external PA mixing desk. 28. [. . . ] EUROPE UNIQUEMENT - Remarque: La consommation en crête du AS100D est de 21 ampères. Note: Cet équipement a été testé et approuvé conforme aux normes fédérales sur les appareils numériques de Classe B selon le résolution fédérale américaine. Ces limites sont désignées pour fournir une protection raisonnable contre les interférence en installation résidentielle. Cet appareil génère, utilise et peut émettre des fréquences radio et, en cas d'installation ou d'utilisation différente de ce qui est préconisé dans ce mode d'emploi, il peut entraver la bonne réception des équipements de télévision ou radio avoisinants. [. . . ]