User manual MINOURA VFS

[. . . ] Remove all oils and moisture from the drive roller and the tire before use. Keep both hands on handlebar at all times and maintain a normal riding position. You should not tighten the wheel axle by tightening the left side knob. [. . . ] You should not tighten the wheel axle by tightening the left side knob. This is for preadjusting the wheel position to the exactly center of the drive roller only. When using the trainer, place it on a flat and level surface for safe training. Keep away from small children, and keep hands and feet away from spinning rollers and wheels at all times. Tighten the pivot bolts on the main frame firmly before installing your bike. -2- VFS-G (without remote shifter) Magnet Inner Housing Fluid Unit Flywheel Cover Flywheel Alloy Rotor Remote Shifter Remote Cable Magnet Remote Cover Spring Remote Ring Remote Bracket Outer Housing Coupling Cover Coupling Tube (L) Inner Housing Fluid Unit Coupling Cover Coupling Tube (R) Hub Knob Bolt Protector Cap Hub Handle M8x20 Bolt Unit Base M8x15 Bolt M8x70 Bolt VFS-G Frame Mount Base Pad Sub Frame 35mm Rubber Foot Cap Sub Frame Back Plate Pad Cover Base Bracket VFS-G-R (with remote shifter) ASSEMBLE YOUR VFS-G TRAINER 1 Assemble the Sub Frame onto the Main Frame: The metal Sub Frame Back Plate must be placed on the bottom of the Sub Frame as shown in Fig. Insert the M8 Nylon Nut into the hole on the backside of the Sub Frame. A> 2 Install the Unit Base bracket to the resistance unit: Make sure the bracket direction is correct as shown in Fig. Wrong direction will not make the next step successful. Unit Base M6x14 Bolt 3 Install the assembled resistance unit onto the Mount Base: Slide the Unit Base bracket into the Mount Base. Now, adjust the coupling angle so that the large cutout clamps and lever are adjusted for easier fitting. Turn the Hub Handle in a counterclockwise direction to close the coupling. After engaging the right end of the quick release skewer (nut side), turn the Hub Handle until it's locked. Now the installation is completed and you are ready to ride. <Fig. J> 5 Now make sure that the Mount Base is not touching the tire (see Fig. Lift up the bike again, straighten the Sub Frame and the Mount Base then ease the wheel down again. If the tire is touching the Sub Frame, the resistance unit position is wrong. Go back to the Step-4 on the page-5 to adjust to the correct position. -7- <Fig. [. . . ] If the tire is touching the Sub Frame, the resistance unit position is wrong. Go back to the Step-4 on the page-5 to adjust to the correct position. -7- <Fig. K> 6 The tire must be positioned in the center area of the drive roller (see Fig. [. . . ]