User manual NAD C555I

[. . . ] 4 Ventilation - The unit should be situated with adequate space around it so that proper ventilation is assured. - Do not place on a bed, rug, or similar surface that may block the ventilation openings. Do not install the unit in a bookcase cabinet, or airtight rack where ventilation may be impeded. 5 Objects and liquid entry - Take care that objects or liquids do not get inside the unit through the ventilation openings. [. . . ] 6 Carts and stands - When placed or mounted on a stand or cart, the unit should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the unit and cart to overturn or fall. 7 Condensation - Moisture may form on the CD pickup lens when: · The unit is moved from a cold spot to a warm spot. Should this occur, leave the unit for a few hours, then try to operate again. 8 Wall or ceiling mounting - The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions. ELECTRIC POWER 1 Power Sources - Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit. 2 Polarization - As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily insert into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet. This will prevent dust falling onto the records and make cleaning unnecessary. 3 Don't use a record cleaner that works as the record plays, or any cleaners that use water or fluids. Visible dust on the record surface is simply brushed aside by the stylus, and any that collects there can easily be blown away. Switch on before the start, and only switch off after the last record has finished. Changing records whilst the platter revolves is easier than it sounds!Disturbance of this can cause serious problems with speed variation and wear. 6 When switching on the turntable, especially at 45rpm, it is recommended to give the platter a quick spin clockwise as the `ON' switch is pressed. Some settling of the anti-vibration feet may cause the turntable to lean backwards slightly after a few months, but this is nothing to worry about. To clean or dust, wipe gently with a soft cotton duster (slightly damp, only if necessary). 9 The tonearm is automatically earthed (or ground) through the arm cable screening. [. . . ] To clean or dust, wipe gently with a soft cotton duster (slightly damp, only if necessary). 9 The tonearm is automatically earthed (or ground) through the arm cable screening. 10 Save the packing , in case the turntable has to be transported in the future. 11 When the record reaches the end of one side, remember to lift the stylus off the surface of the record using the lift/lower mechanism. [. . . ]