User manual NAIM NA IBL

[. . . ] Each of these is introduced in the following paragraphs and subsequently described in full detail in Sections 5 to 8. The SuperUniti elements are: An Integrated Stereo Amplifier A Multi-mode Radio A UPnPTM Audio Interface A USB/iPod Interface Introduced Introduced Introduced Introduced below below below below and and and and fully fully fully fully described described described described in in in in Section Section Section Section 5 6 7 8 Prior to the sections describing SuperUniti elements, Section 2 covers its installation and connection, Section 3 describes its operation and Section 4 describes its setup. 1. 1 The Integr ate d Amplif ie r 1. 1. 1 Inputs SuperUniti incorporates an audio preamplifier that provides four analogue and six S/PDIF digital audio external inputs. The preamplifier also accepts internal inputs from SuperUniti's integrated FM/DAB tuner. [. . . ] The preamplifier and subwoofer outputs are disabled when Internal Only is selected. 11 Su p e rU niti Setup Select External if an external power amplifier is to be used in place of the SuperUniti internal power amplifier. The preamplifier and subwoofer outputs are enabled when External is selected. Select All Outputs if an external power amplifier or subwoofer is to be used in conjunction with the SuperUniti internal power amplifier. Volume and Balance parameters specify maximum allowed volume, and the channel balance respectively. Note: If SuperUniti is connected to the network both wirelessly and via Ethernet (wired), the Ethernet connection will take priority. 4. 6. 1 Wireless Network Connection Set Up Select Network <Don't Use Wireless> LingNet 4GreenNet TomNet 3/6 4. Volume: Options 0 to 100 (adjust using handset 6 or 5 keys) Headphones 4Max. Volume: 1/1 100 If the Wireless parameter is selected in the Network Settings menu the Select Network menu will display a list of the available networks. Use the handset up (5) or down (6) keys to scroll through the list and the ok/list key to select a network. Note: SuperUniti is compatible with most commonly used Wi-Fi standards. Routers that support 802. 11b and 802. 11g will work, however those with 802. 11n compatibility are recommended for best results. Note: As with any wireless network hardware, SuperUniti connection reliability will be affected by both network router performance and Wi-Fi signal quality. Note: If WEP security is used the router should be set to "auto" or "open" authentication. If the selected network is insecure and requires no passphrase or access key to join, SuperUniti will display an alert message. Pressing the handset ok/list key will immediately connect SuperUniti to the network and display a confirmation screen. This wireless network is insecure and requires no passphrase or access key. Press OK To Connect 4. 7 The Digital Output Menu The Digital Output setup menu enables the SuperUniti digital output to be switched on and its signal format configured. Parameter Enabled: Output: Digital Output 4Enabled: Output: 1/2 No 96kHz 24bit Options Yes / No Native / 96kHz 24bit If Native is selected, the digital output format will reflect the input format. If 96kHz 24bit is selected, the output is re-sampled to 96kHz and 24bit resolution. 4. 8 The Front Display Menu The Front Display setup menu enables the behaviour of the front panel display, logo illumination, clock display and logo touch-muting to be modified. Parameter Off During Mute: Auto Off: Clock When Off: Logo Off: Logo Mute: Options Yes / No Select time from list Yes / No If Muted / If Display Off / Always / Never Yes / No Front Display 1/5 4Off During Mute: No Auto Off: 2 mins Clock When Off Yes Logo Off If Muted Note: Wireless connection difficulties can sometimes be resolved by changing the wireless connection channel in the router settings. 4. 6. 2 Non-DHCP (Static) Network Connection If DHCP is de-selected in the Network Settings menu, five further parameters will be displayed. Parameter IP: Network Settings 4IP: Mask: Gtwy: DNS1: 1/5 192. 168. 0. 80 255. 255. 255. 0 192. 168. 0. 1 192. 168. 0. 1 When Off During Mute is selected the front panel display will switch off when mute is engaged. Auto Off defines the length of time the display will remain switched on after the last interface operation is carried out. Note: If the display has been switched off using the handset disp key this setting will take priority over the Auto Off setting. The display will always switch on briefly when control commands are received. [. . . ] 2 A udio File C o mpatibility The audio files stored on the UPnPTM servers attached to the network may be in MP3, M4A, Apple Lossless, AAC, LPCM16/24, FLAC, WMA, WAV, AIFF or Ogg Vorbis formats. Files must be free of any digital rights management playback restrictions such as the Apple iTunes FairPlay system. 7. 3 S canning Se rv e rs and P laying Fi l es When the SuperUniti UPnPTM input UPnP 1/3 is selected a list of available 4Allegro Media Server UPnPTM servers on the network NAS Disk UnitiServe will be displayed. The display will automatically enter list mode so the handset up (5), down (6 )and ok/list keys can be used to browse and select the desired server. [. . . ]