User manual NILFISK GD 110

[. . . ] This vacuum cleaner is designed to be safe when used for cleaning functions as specified. Should damage occur to electrical or mechanical parts, the cleaner and / or accessory should be repaired by the manufacturer, authorised dealer or competent service centre before use in order to avoid further damage to the machine or physical injury to the user. [. . . ] This cable is available from the manufacturerer and authorised dealers and must be installed by trained personnel. The vacuum cleaner is equipped with a thermal cut-out to protect the motor and other vital machine parts from overheating. Should the machine cut out, you will have to wait at least 5-10 minutes for it to automatically reset. While you are waiting, switch the machine off and unplug it, then check the hose, dust bag and filter to be sure that nothing is blocking the flow of air through the machine. Remove the plug from the socket before performing service or maintenance. This appliance conforms with EC-Directive 89/336/EEC, 73/23/EEC, 93/68/EEC. THIS VACUUM CLEANER is designed, developed and rigorously tested to function efficiently and safely when properly maintained and used in accordance with the following instructions. These instructions have been prepared with safety and efficiency paramount. THE MACHINE OPERATOR must understand these instructions for use, and be made aware of any relevant regulations and legislation in force at the time of use. CAUTION - This machine is not suitable for use in explosive or inflammable atmospheres or where such atmospheres are likely to be produced by the presence of volatile liquid or inflammable gas or vapour. CAUTION - In no circumstances should the power supply cord be wrapped around fingers or any part of the operators person. CAUTION - The electrical supply plug must not be subjected to undue stress by pulling on the power supply cord. Your MACHINE must only be connected to an electrical supply of the same voltage and frequency as indicated on the rating plate. Ensure that the plug fitted to the end of the power supply cord is suitable for your supply socket, if not refer to the information contained in 'Electrical Connections', or consult a qualified electrician. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]