User manual NILFISK UHB 51-1500

[. . . ] Do not use this machine with or near fuels, grain dust, solvents, thinners, or other flammable materials. Make sure that you unplug the AC charger from the wall outlet before disconnecting from the machine. Send batteries to lead smelter for reclamation following applicable federal, state and local regulations. Always wear eye protection and protective clothing when working near batteries. [. . . ] Please specify the Model and Serial Number when discussing your machine. Remove all jewelry Do not smoke Wear safety glasses Work in a well-ventilated area Do not allow tools to touch more than one battery terminal at a time. The Model Number and Serial Number of your machine are shown on the Nameplate on the bottom of the machine. This information is needed when ordering repair parts for the machine. Use the space below to note the Model Number and Serial Number of your machine for future reference. Electrical components in this machine can be severely damaged if the batteries are not installed and connected properly. Batteries should be installed by your local Nilfisk dealer or by a qualified electricain. The UHB 51-1500 may be used with three 12 volt 185 amp hour batteries or three 12 volt 234 amp hour AGM batteries. The battery charger must be reprogrammed when switching from lead acid to AGM batteries. When the machine is delivered, carefully inspect the shipping carton and the machine for damage. If damage is evident, save the shipping carton so that it can be inspected. Contact the Nilfisk Customer Service Department immediately to file a freight damage claim (phone number is provided on the back cover of this manual). Your local Nilfisk distributor can provide the proper pads and floor finishes for use with this machine. the pad must be centered properly on the pad holder to prevent machine vibration. For pad installation, follow the steps below (see steps 1 - 6 in Figure C): While holding the pad retainer with one hand, rotate the pad and pad driver counter clockwise to loosen the pad retainer. Remove the old pad and install a new one, being careful to center it on the pad driver. Raise the back of the machine to lower the pad housing by lifting as shown. Your local Nilfisk distributor can provide the proper pads and floor finishes for use with this machine. Install the battery cables as shown in figure B, with the terminals marked "P" on the positive battery posts and the terminals marked "N" on the negative battery posts. Position the cables so that the caps can be easily removed when it is necessary to add water to the batteries. [. . . ] (E) PAD ASSIST MACHINE DOES NOT PULL ITSELF For pad assist adjustment, follow the steps below (see steps 1 - 6 in Figure E): 1 Tip burnisher back as shown to gain access to the pivot bracket. If the deck is angled too much it could result in the pad burning the floor on the RH side. 4 Desserrez la système de réglage du support du pivot et les boulons du pivot, puis faites tourner le support dans le sens contraire des aiguilles d'une montre pour augmenter l'assistance du disque. This parts list is for machines after serial number EA Specify the model and serial number of the machine. [. . . ]