User manual SEVERIN BA 3258

[. . . ] When removing the plug from the wall socket, never pull on the power cord; always grip the plug itself. This appliance is not intended for use by any person (including children) with reduced physical, sensory or mental capabilities, or lacking experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Do not operate the appliance if excessive force has been used to pull the power cord. [. . . ] - Close the water fill hole. 6 General information about ironing Always check first whether a label with ironing instructions is attached to the article to be ironed. - The meaning of the ironing symbols is as follows: · synthetics (low temperature) ·· silk and wool (medium temperature) ··· cotton and linen (high temperature) - These markings can also be found on the temperature control knob of the steam iron in form of dot symbols. Laundry to be ironed should be sorted according to the fabric ironing temperature. When ironing highly sensitive fabrics, or if you are not sure about the fabrics, you may carefully test-iron at a non-visible point, e. g. If the laundry is being dried in a dryer before ironing, the temperature should be adjusted to "iron dry". Start up Clean the steam iron before using for the first time, according to the instructions given in the paragraph "General Care and Cleaning". This will result in the removal of possible dust particles from the soleplate and subsequently lessen the smell typically encountered when first switching on. The temperature level for steam ironing is indicated on the temperature control knob. - After filling the reservoir with water, place the steam iron upright on its base stand and insert the plug into the wall socket. - Set the temperature control knob to the required ironing temperature as indicated by the ironing symbols. - During the heating-up process the green and red indicator light will be on. The red indicator light will go out once the required ironing temperature is reached. Before ironing any fabrics, the soleplate should be cleaned by passing it over an old, clean cotton cloth, while using the steam jet function; this helps to flush out any dirt residues or lint particles trapped inside the openings in the soleplate. The steam output can be adjusted to different levels with the steam control button, or turned off completely for dry ironing. Should there be water left in the reservoir, the steam jet function may also be used when dry-ironing at higher temperature settings. Place the steam iron upright on its base stand after use and remove the plug from the wall socket. Automatic switch-off If the appliance is switched on but not being used for a certain period of time, it will automatically switch off. This automatic switch-off is indicated by an acoustic signal; in addition, the green indicator light is flashing. Horizontal position: With the iron standing on its soleplate, it will switch off after approx 30 seconds of inactivity. Vertical position: When upright on its base stand, the iron will switch off after approx. Steam Jet When the steam jet button is depressed, an additional hot steam jet is emitted from the 7 soleplate. This function can be very useful when the regular amount of steam emitted is not sufficient to remove stubborn creases or when ironing difficult or thick fabrics. The steam jet function may also be used with the iron held vertically, to remove creases or wrinkles from fabrics. [. . . ] - Pour any remaining water out of the reservoir through the water fill hole. To avoid damage to the soleplate, store the steam iron in upright position on its base stand. Disposal Do not dispose of old or defective appliances in domestic garbage; this should only be done through public collection points. Guarantee This product is guaranteed against defects in materials and workmanship for a period of two years from the date of purchase. [. . . ]