User manual SUNBEAM H2O

[. . . ] It will provide you with many years of trouble free use, by following the simple i n s t r u ct i o n s contained in this manual. 1) Remove the water dispenser from the cardboard box without turning it upside down, or laying it on its side. The refrigeration compressor has very sensitive mounts inside of its welded shell in order to provide quiet running. 3) Find a location for your water dispenser that is protected from direct sunlight and other sources of heat. [. . . ] The hot water thermostat is factory set between 88ºC and 89ºC (190. The hot and cold indicator lights will be on while the system is working. Once the desired temperatures have been reached, the lights will go off. ⷠIf you choose to set the cold water thermostat to the lowest setting, it may take over one hour to cool the water down to the coldest setting. ⷠBefore the water dispenser leaves the factory, the thermostat is set properly. It is not advisable to adjust the thermostat when using the water dispenser for the first time. NOTE: When your water dispenser is in operation there is a small amount of water in the water passage between the water tanks and the taps. This water is not controlled by the cold, hot or room temperature settings. We recommend that in order to fully enjoy the desired water setting, you should eliminate this small amount, 200ml - 400ml (6. For the cold water, there is a 304 stainless steel water cooling tank. For the hot water there is a 304 stainless steel heavy duty hot water tank with an external heater. Turn it back on after the new bottle has been placed and the air is purged from the dispensing buttons. Wipe the outside of the water dispenser with a soft cloth dampened with liquid dish washing soap. 4) Twist the bottle receptacle of the No-Spill system counterclockwise and pull it up (A). 5) Take apart the No-spill system by unscrewing the base (piercing pin) (B). Then proceed to wash it with a dish washing fluid, rinse it and reassemble. 6) Empty both tanks (hot and cold) by removing the cap and rubber gasket around drain plug located on the side of the unit. 7) Clean the inside of the water dispenser periodically with CLR solution (Calcium, Lime, Rust removal) available at most hardware stores. If not available, you can use v i n egar or a 2% citric acid solution. iT IS IMPORTANT TO LET THE WATER DISPENSER DRY FOR TWO HOURS BEFORE PLUGGING IT BACK IN. 8) The harder the water you use, the more often you should clean the interior of the unit. Recommended intervals are between one and three months depending on the mineral content of the water and the frequency of bottle changes. [. . . ] If you need to unfreeze it in a hurry, then turn off and unplug the unit and remove the water bottle. Keep draining hot water and pouring it back into the water receptacle. Once the tank is unfrozen, plug the unit back in, turn on the switch and reset all the thermostat settings. 6c) If you will be continuing to use the cooling compartment, keep the door closed and reduce the cooling load inside of the cooling compartment. [. . . ]