User manual THUNDER TIGER BANDIT OBL ASSEMBLY

[. . . ] (3) Clean off the exhaust residue from the muffler, engine, and helicopter. for unusual wear. Trouble Shooting [1]The engine will not start. * The engine starting shaft will not turn: The engine may be flooded with too much fuel. [. . . ] Please remove the glow plug first, then turn the engine with the electric starter until the excess fuel spits out of the glow plug hole. * The engine turns when the electric starter is applied, but the engine will not start: (1) Is the glow plug working?Remove the glow plug and does the platinum coil glow red when a 1. 5 volt battery is applied to the plug?Please refer to the engine instruction manual for the proper needle setting. (3) Does the throttle control arm move properly and in the correct direction according your transmitter command?Once proper needle settings are achieved, model should lift off effortlessly. [2] Helicopter problems. * The helicopter shakes. (4) Are the two control paddles mounted at the same distance from the rotor shaft, and the paddles are parallel to each other, and in the proper direction?(6) Are the main rotor blades damaged or mounted in the proper orientation?The blade balance can be checked by removing both blades and then use one of the 4mm blade bolt and nut to hold the two blades together like a teeter totter. If not, then add some tape to the lighter blade near the blade tip until the two blades teeter in a level position. [. . . ] The blade balance can be checked by removing both blades and then use one of the 4mm blade bolt and nut to hold the two blades together like a teeter totter. If not, then add some tape to the lighter blade near the blade tip until the two blades teeter in a level position. [. . . ]