User manual THUNDER TIGER KATANA ASSEMBLY

[. . . ] Always check if there are any modelers operating on the same frequency as you are. Use an adequate charger for the batteries and follow the instruction correctly. Right after use, do not touch equipment on the model because they may generate high temperatures!The ESC may fail if power is applied to the motor when car cannot move freely. [. . . ] Thunder Tiger and its distributor have no control over damage resulting from shipping, improper building materials, construction, or improper usage. By the act of assembling or operating this product, the user accepts all resulting liability. If the buyer is not prepared to accept this liability, then he/she return this product in new, unassembled, and unused condition to the place of purchase. WARNING: To avoid a possible fire hazard, ALWAYS unplug the battery after use. Do NOT leave your vehicle unattended with the battery plugged in. ITEMS REQUIRED FOR OPERATION For Car Ni-MH Battery Pack 2974 IB Ni-MH Batter Pack, 7. 2V/IB3000 2977 IB Ni-MH Batter Pack, 7. 2V/IB4200 For Transmitter Nose Plier, Philips Screwdriver, Allen Wrench Alkaline Batteries(8), AA-size Power Charger (AC/DC Charger) 2605AC 110V/7. 2-8. 4V 2606AC 230V/7. 2-8. 4V (2P) 2607AC 230V/7. 2-8. 4V (3P) ITEMS INCLUDED Electric Speed Control 8050 ACE R/C VELOCI RS 2-Channel Surface or Pistol Radio with Standard Servo. Motor SUPER 17 TOOLS INCLUDED Hex Wrench Set 4-Way Wrench 1 INSTALLING STEERING SERVO LINKAGE (Skip if already assembled) a b c d a. Find the appropriate servo horn for your servo. Remove the servo horn from your servo and replace with the stock horn, then fasten with the stock mounting screw. Assemble the servo link, matching the length to the true scale drawing. d. 2 INSTALLING THE RADIO GEAR (Skip if already assembled) a b c d e a. Cut a piece of double side tape, remove the paper from one side, and attach it to the bottom of your receiver. d. Remove the paper from the other side and attach to the chassis as shown. e. Plug the small BEC plug into the receiver's on/off switch. Leave the throttle stick at the neutral position and the throttle trim knob/lever in the middle i. Press the set-up button, the neutral setting is now stored, and the set-up LED lightens GREEN. The full-throttle setting is now stored, and the set-up LED lightens RED. The brake setting is now stored, and the set-up LED flashes 3 times simultaneously and then goes RED/GREEN light still. CONGRATULATIONS! Your electric speed control is now completely set-up and ready to run. The transmitter is always the FIRST TO BE TURNED ON and THE LAST TURNED OFF. If you make a mistake during the set-up procedure, don't worry: disconnect the battery for about 10 seconds and start again from the first step. Refer to the instruction manual for more information on setting the electric speed control. 8 VELOCI SPECIAL FEATURE The VELOCI digital speed controls feature a new overheat protection function. This function protects the VELOCI against overheating during operation. If the speed controls temperature exceeds safe levels, the motor function will be temporarily switched off. However, full steering function is still maintained during this period. [. . . ] However, full steering function is still maintained during this period. When the overheat protection mode is activated, the setup LED will flash GREEN and RED simultaneously. Simply wait a few minutes to allow the speed control to cool down to normal operating temperatures and full function will be restored. Not enough ventilation to the speed control. 9 BATTERY CHARGING (Battery products and charger are not included in kit) a. [. . . ]