User manual TOMY DUSTBOT

[. . . ] Once a connection is made between Baby and Parent Units, normal monitoring will start. The Sound Level Lights Display reacts to sound: the louder the sound, the more lights illuminate. Identify the cause of audible alarm by using the following table; should you be unable to identify or rectify the cause of the problem, please refer to the Simple Solution Guide within this booklet. Button will change from solid green to alternating flashing green and red. [. . . ] INDEPENDENT NIGHTLIGHT As your baby grows older you can use the Nightlight without monitoring and without the need for the Parent Unit. with the Baby Unit switched OFF , press and hold the button and the Nightlight will illuminate. The button will glow red (instead of the usual green), indicating that the monitor is not switched ON. Adjust the volume from zero (mute) to level 10 (max) by moving the thumb wheel clockwise to increase or anticlockwise to decrease. SOUND LEVEL LIGHTS DISPLAY The Sound Level Lights Display on your Parent Unit reacts to the sounds of your baby. You can lower the volume of the Parent Unit whilst still watching out for baby, ideal for when you're relaxing or entertaining. SOUND ACTIVATED MONITORING For those quiet moments or when your baby is a little older you may not want to hear every sound in your baby's room. Your Baby Monitor has a Sound Activated Monitoring mode, a feature that only captures sounds above a preset threshold, for example a cry rather than a gurgle. select Sound Activated Monitoring by pressing the button on the Parent Unit. Every time your baby's sounds rise above the threshold this feature will be interrupted instantly and normal sound monitoring will continue until your baby settles again. 2-WAY TALKBACK For that little extra reassurance and convenience, your monitor has a 2-Way Talkback feature that allows you to speak to your baby. Be careful not to position the adaptor where a child is likely to use it as a step. Putting weight on the adaptor while it is plugged in could damage the unit or cause injury to your child. It is normal for chargers to become hot during use ­ take care when handling, allow heat to disperse. To prevent a shock hazard, please disconnect from power supply before cleaning. The rechargeable battery maybe below the Place the Parent Unit on charge and leave for several minutes before switching ON. BATTERY SAFETY Removal and replacement of batteries should be carried out by an adult or under adult supervision. Take special care to ensure batteries are inserted correctly, observing (+) and (-) polarity marks on battery and product. Do not mix old (used) and new batteries or batteries of different types, e. Remove batteries from product after use or if storing for long periods. Only use batteries of the same or equivalent type to those recommended. Removal and recharging of rechargeable batteries should be carried out by an adult or under adult supervision. [. . . ] Ensure both units are adequately powered and then follow the `Set-Up' guide within this booklet. Identify the low battery condition and either recharge/replace batteries or switch to mains power. Should your monitor not be operating as expected, the information listed below should be adequate to resolve your problems; alternatively a more comprehensive guide can be found on our website: www. Either, your Parent Unit will charge whilst switched on or off, however charging the unit whilst switched on will allow you to monitor your baby whilst charging. [. . . ]