User manual TRONIC KH 3002 MOBILE POWER SUPPLY

[. . . ] The safety concept can work only if the appliance is in a faultless condition. ⷠThe plug must always be easily accessible, so that the appliance can be quickly separated from the mains power supply in the event of an emergency. To avoid risks, arrange for defective power plugs and/ or cables to be replaced at once by qualified technicians or our Customer Service Department. ⷠNever submerge the appliance or the power supply unit in water. [. . . ] Should the adapter plugs be connected with positive to positive and negative to negative on the adapter cable , then on the adapter plugs positive is above resp. Before performing any connections, always check to ensure that both the appliance to be supplied and the Energy Station are switched off. place the main switch 2 in the "OFF" position (centre position). Should the adapter plugs be connected with opposite markings (+ and -) on the adapter cable , then on the adapter plugs positive is outside and negative is inside. Now you can withdraw the adapter cable plugs from both the appliance and the Energy Station. If neither of the two LEDs, 5 and 6, light up after switching on, then the 10 amp fuse 8 on the Energy Station might have blown. Should an LED light up on the Energy Station after switching on, but the appliance fails to work, immediately switch the Energy Station off. check to ensure that the cable is correctly connected ­ and "Positive" and "Negative" have not been switched. If required, also check the fuse in your appliance, as described in its operating instructions. For as long as sufficient energy is available for the appliance being supplied, the green LED "Full" 5 is illuminated in the OUTPUT field. When there no longer sufficient energy available for the appliance being supplied, the red LED "Empty" 5 is illuminated in the OUTPUT field. You must first recharge the battery when the red LED "Empty" 5 is illuminated. Otherwise the battery will be depleted, usually resulting in a considerable loss of charging capacity. In this way you prevent current flowing while the connector is being withdrawn. Before performing any connections, always check to ensure that both the appliance to be supplied and the Energy Station are switched off. place the main switch 2 in the "OFF" position (centre position). Please bear in mind that with a 10 A load the battery will be exhausted after not more than 45 minutes ­ subject to the battery charge condition, even earlier. With a battery capacity of 7 Ah, this corresponds to just under 2 hours of operating time. You can roughly estimate the operating time for your appliance using this calculation example. Place the main switch 2 at "ON" ­ your appliance will now be supplied with power. For as long as sufficient energy is available for the appliance being supplied, the green LED "Full" 5 is illuminated in the OUTPUT field. When there no longer sufficient energy available for the appliance being supplied, the red LED "Empty" 5 is illuminated in the OUTPUT field. [. . . ] Dispose of this appliance through an approved waste disposal centre or at your community waste facility. All consumers are statutorily required to dispose of batteries or cells at a collection point in their community or at a retail company. The purpose of this obligation is to ensure that batteries are disposed of in a non-polluting manner. The warranty for this appliance is for 3 years from the date of purchase. [. . . ]