User manual TYAN TIGER I7525

[. . . ] Tiger i7525 (S2672) User's Manual Tiger i7525 /// Revision 1. 00 (S2672) Copyright © TYAN Computer Corporation, 2004-2005. No part of this manual may be reproduced or translated without prior written consent from TYAN Computer Corp. All registered and unregistered trademarks and company names contained in this manual are property of their respective owners including, but not limited to the following. TYAN, Tiger i7525 and (S2672) are trademarks of TYAN Computer Corporation. [. . . ] Configure parallel port using options: [Disabled] No configuration [Enabled] User configuration [Auto] BIOS or OS chooses configuration. Set the DMA channel for the parallel port. Base I/O Address: Interrupt: Parallel Port: 3F8 2F8 3E8 2E8 IRQ3 IRQ4 Auto Enabled Disabled Mode: Base I/O Address: Interrupt: DMA channel: ECP EPP Bi-directional Output only 378 278 3BC IRQ5 IRQ7 DMA1 DMA3 41 http://www. tyan. com Thunder i7525 (S2676) 4. 3. 14 Advanced Submenu PCI Configuration PCI Express x16: PCI Device, Slot #1 PCI Device, Slot #2 PCI Device, Slot #3 PCI Device, Slot #4 PCI Device, Slot #5 [Auto] PCI/PNP IRQ Exclusion Setup Item PCI Express x16 Selections (Default values are in bold) Auto Disabled Enabled Item Specific Help Configures the Express x16 Slot: PCI [Auto] BIOS configures the slot. Reserve specific IRQs for use by legacy devices. 42 http://www. tyan. com PCI Device, Slot #1 PCI Device, Slot #2 PCI Device, Slot #3 PCI Device, Slot #4 PCI Device, Slot #5 PCI/PNP Exclusion IRQ - Thunder i7525 (S2676) 4. 3. 15 Advanced PCI Configuration Submenu PCI Device, Slot #x Option ROM Scan: Latency Timer: [Enabled] [Default] Setup Item Option ROM Scan: Latency Timer: Selections (Default values are in bold) Enabled Disabled Default 0020h 0040h 0060h 0080h 00A0h 00C0h 00E0h Item Specific Help Initialize device expansion ROM. Minimum guaranteed time slice allotted for bus master in units of PCI bus clocks. 4. 3. 16 Advanced Exclusion PCI Configuration Submenu PCI/PNP IRQ IRQ3: IRQ4: IRQ5: IRQ7: IRQ10: IRQ11: [Available] [Available] [Available] [Available] [Available] [Available] Setup Item IRQ3 Selections (Default values are in bold) Available 43 http://www. tyan. com Item Specific Help Reserves the specified Thunder i7525 (S2676) Reserved IRQ4 IRQ5 IRQ7 IRQ10 IRQ11 Available Reserved Available Reserved Available Reserved Available Reserved Available Reserved IRQ for use by legacy devices. Reserves the specified IRQ for use by legacy devices. 4. 4 ­ Security Menu Setup Password User Password Set Setup Password: Set User Password: Password on boot: Start from Floppy: Start from IDE CD-ROM: Setup Prompt: Fixed disk boot sector: Write on Flexible Disks: BIOS Write Protect: Cabinet Monitoring: Trusted Platform Module: Not Installed Not Installed [Enter] [Enter] [Disabled] [Enabled] [Enabled] [Enabled] [Normal] [Disabled] [Disabled] [Disabled] [Disabled] 44 http://www. tyan. com Thunder i7525 (S2676) Setup Item Setup Password User Password Set Setup Password: Selections (Default values are in bold) `Installed' or `Not Installed' `Installed' or `Not Installed' Enter Item Specific Help Setup Password controls access to the setup utility. Use at least 4 characters for the password; otherwise the system can be tampered easily. Use at least 4 characters for the password; otherwise the system can be tampered easily. Display setup entry prompt on boot; disabled doesn´t prevent setup entry. [Unlocked] Data can be written to Set User Password: Enter Password on boot: Start from Floppy: Disabled Enabled Enabled Disabled Start from IDE CDROM: Enabled Disabled Setup Prompt: Enabled Disabled Fixed disk boot sector: Write Disks: on Flexible Normal Write Protect Unlocked Locked 45 http://www. tyan. com Thunder i7525 (S2676) floppy disk. Allows to enable the Trusted Platform Module (TPM). BIOS Write Protect: Cabinet Monitoring: Trusted Module: Platform Disabled Enabled Disabled Enabled Disabled Enabled 4. 5 ­ Power Menu APM Interface: APM Power Saving: Standby Timeout: Suspend Timeout: APM Resume Timer: APM Resume Time: Power-on via LAN: Power-off via Keyboard: Power Failure Recovery: [Enabled] [Customized] [15 min] [Disabled] [Disabled] [00:00:00] [Enabled] [Disabled] [Last State] Setup Item APM Interface: Selections (Default values are in bold) Enabled Disabled Item Specific Help Enable/Disable Advanced Power Management (APM) BIOS-interface for non-ACPI operating systems. Configure the BIOScontrolled APM. APM Power Saving: Disabled Customized Maximum Power 46 http://www. tyan. com Thunder i7525 (S2676) Savings Minimum Savings Power [Disabled] No BIOS-controlled power management. Allows the system to be switched off via power button on the keyboard. After recovery form power failure: Standby Timeout: Suspend Timeout: APM Resume Timer: Disabled 2 min 5 min 10 min 15 min 30 min Disabled 2 min 15 min 30 min 1h 2h Disabled Enabled 00:00:00 . . . 23:59:59 APM Resume Time: Power-on via LAN: Power-off Keyboard: Power Recovery: via Failure Enabled Disabled Disabled Enabled Last State Stay Off 47 http://www. tyan. com Thunder i7525 (S2676) Power On [Stay off] Switch off. [Last State] Switch to the state the system was in before power failure. 4. 6 ­ Boot Menu Halt on POST Errors: Fast Boot: Quiet Boot: Boot Menu: Boot Device Priority [Enabled] [Enabled] [Enabled] [Enabled] Setup Item Halt on POST Errors: Selections (Default values are in bold) Enabled Disabled Item Specific Help Pauses and displays setup entry or resume boot prompt if error occurs at boot. Allows you to bypass the normal sequence of Fast Boot: Enabled Disabled Quiet Boot: Boot Menu: Enabled Disabled Enabled Disabled 48 http://www. tyan. com Thunder i7525 (S2676) Boot Device Priority - boot devices. Before loading the OS press <F12> and select an alternate boot device from a menu. Select which order the BIOS should use between devices when trying to boot. 4. 6. 1 Boot Submenu Boot Device Priority + Removable Devices + Hard Drives + CD-ROM Drives Network Boot Setup Item - Selections (Default values are in bold) - Item Specific Help Keys used to view or configure devices: <Enter> expands or collapses devices. <Ctrl+Enter> expands all <Shift+1> enables or disables a device. <n> Move a removable device between Hard Disk or Removable Disk 49 http://www. tyan. com Thunder i7525 (S2676) 4. 7 ­ Exit Menu Save Changes & Exit Discard Changes & Exit Get Default Values Load Previous Values Setup Item Save Changes & Exit Discard Changes & Exit Get Default Values Load Previous Values Selections (Default values are in bold) - Item Specific Help Exit System Setup and save your changes to CMOS. Load Previous values from CMOS for all Setup items. 50 http://www. tyan. com Tiger i7525 (S2672) Chapter 4: Diagnostics Chapter 5: Diagnostics Note: if you experience problems with setting up your system, always check the following things in the following order: Memory, Video, CPU By checking these items, you will most likely find out what the problem might have been when setting up your system. [. . . ] (Optional Feature) Show message for entering AWDFLASH. EXE from FDD (optional) 1. Initialize PS/2 Mouse 4Eh: 50h: 52h: 53h: 55h: 57h: 59h: 5Bh: 5Dh: 60h: 63h: 65h: 48 http://www. tyan. com Tiger i7525 (S2672) POST (hex) 67h: 69h: 6Bh: Description Appendix II: Post Error Code for BIOS Prepare memory size information for function call: INT 15h ax=E820h Turn on L2 cache Program chipset registers according to items described in Setup & Autoconfiguration table. Auto assign ports to onboard COM ports if the corresponding item in Setup is set to "AUTO". (Optional Feature) Enter AWDFLASH. EXE if: -AWDFLASH. EXE is found in floppy drive. [. . . ]