User manual TYAN TOMCAT I7221A

[. . . ] Tomcat i7221A S5151 User's Manual Tomcat i7221A /// Revision 1. 0 S5151 Copyright © TYAN Computer Corporation, 2004-2005. No part of this manual may be reproduced or translated without prior written consent from TYAN Computer Corp. All registered and unregistered trademarks and company names contained in this manual are property of their respective owners including, but not limited to the following. TYAN, Tomcat, i7221 and S5151 are trademarks of TYAN Computer Corporation. [. . . ] In both of these modes, the system activities are detected by monitoring the IRQ signals or I/O. Modem Use IRQ This setting allows you to select the interrupt request (IRQ) line assigned to the modem (if any) on your system. NA / 3 / 4 / 5 / 7 / 9 / 10 / 11 Suspend Mode This setting defines the method used to power down the system. HDD Power Down This setting defines the delay before the hard drive is powered down. Intruder# Detection 3-23 http://www. tyan. com Tomcat i7221A S5151 Chapter 3: BIOS Setup When enabled, this option prevents chassis intrusion. Once you open the system casing, the system marks the chassis as open. Even if you close the casing again, the system still records the chassis as open. Enabled / Disabled Intruder# Detection When set to Clear, this option will clear the intruder detection flag number and will auto set the option to Keep when the system is rebooted. Clear / Keep 3. 7. 1 Power On Setup Soft-Off by PWR-BTTN This determines how long the power button needs to be pressed to switch off the PC. PWRON After PWR-Fail This option defines the state of the system when power fails and returns again. If On is selected, the system automatically switches on when power is resumed. If Former-Sts is selected, the system automatically switches on and restores itself to the state it was last in when power failed. Former-Sts / On / Off Wake-Up by PCI Card If enabled, this option awakens the system from a soft off state with an input signal from PME on the PCI card. Enabled / Disabled USB KB Wake-Up From S3 If you have a USB keyboard, then you must enable this function to wake-up the system with a key press. Enabled / Disabled Note This option is enabled only if S3 or S1 & S3 is selected from the ACPI Suspend Type option. 3-24 http://www. tyan. com Tomcat i7221A S5151 Resume by Alarm This option allows your system to turn on at a pre-selected time. Enabled / Disabled Chapter 3: BIOS Setup Date <of Month> Alarm Set the date on which the system should turn on every month. Time <hh:mm:ss> Alarm Set the time on which the system should turn on depending on the date setting. Note The Date and Time functions are enabled only when the Resume by Alarm function is enabled. POWER ON Function This option defines how the system can be woken from sleep mode. Button only / Any key 3. 7. 2 Reload Global Timer Events Each of these options can be set to disabled or enabled. If enabled, then activity from the corresponding device will reload the global timer. Primary IDE 0/1 When set to "On", any event that occurs will awaken a system which has been powered down. [. . . ] Program P6 class write combining Update keyboard LED & typematic rate 1. Boot attempt (INT 19h) 83h: 84h: 85h: 87h: 89h: 8Bh: 8Dh: 8Fh: 93h: 94h: 95h: 96h: FFh: 6-11 http://www. tyan. com Tomcat i7221A S5151 Technical Support Technical Support If a problem arises with your system, you should first turn to your dealer for direct support. Your system has most likely been configured or designed by them and they should have the best idea of what hardware and software your system contains. Furthermore, if you purchased your system from a dealer near you, take the system to them directly to have it serviced instead of attempting to do so yourself (which can have expensive consequences). [. . . ]