User manual X10 KR15A

[. . . ] Big Red Panic Button Remote, Model KR15A INSTALLATION AND OPERATING INSTRUCTIONS The KR15A sends wireless Radio Frequency (RF) signals to an X10 Transceiver (RR501 or TM751) or any X10 security system base console, which receives the RF signals from the KR15A and passes them onto your house wiring. These signals are then received by X10 Remote Sirens and Lamp, Appliance, or Wall Switch Modules to control lights (or appliances) around your home. [. . . ] If you own an X10 security system you can install the KR15A into the Console just like you would any other remote control, door/window sensor, or motion sensor. Just place the Console in the INSTALL mode and press the red button on the KR15A for several seconds (until the Console chimes). Now when you press (and hold) the red button, first the Lamp Module will turn on, then the SH10A will ding, then the SH10A will alarm, then the security system's console will trip. The Console will then call a friend/neighbor, or call ORCA Monitoring Services, depending on which model of security system you own. To change the House/Unit Code for the KR15A: Press and hold the Unit button (under the battery compartment lid) until the red light blinks twice, then release and press the button the desired number of times for the Unit Code you want (once for Unit Code 1, twice for Unit Code 2, etc. ). The light blinks each time you press, and confirms your entry by blinking about 2 seconds after your last press. Use the same procedure to change the Housecode (pressing the House button instead). To confirm the code you've set: press the House or Unit code button - the light blinks back the appropriate number of times for the code that is set. F. C. C. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. [. . . ] If service is required under this warranty: Call 1-800-442-5065, visit www. x10. com, or e-mail support@x10. com. For help or more information on setup, please visit: http://www. x10. com/support KR15A-11/02 [. . . ]