User manual X10 MS10A

[. . . ] Motion Sensor, Model MS10A Set Up and Operating Instructions Installation 1. [. . . ] Wait about 45 seconds for the Motion Sensor to settle, arm the console in the Away mode, then walk past the Motion Sensor. Replacing batteries Slide the battery compartment cover off and replace the batteries with four AA alkaline batteries. After replacing the batteries, the following steps are necessary to determine that the Console still recognizes the Motion Sensor. If the appropriate zone indicator blinks, then the Console recognized the Motion Sensor and no further action is necessary. SENSITIVITY HIGH LOW If the zone indicator didn't blink in step 2 above: TEST CODE 7. To set up additional Motion Sensors (up to 16*) repeat the above steps. Operation When the Security System is armed using a Key Chain Remote (KR10A) the Motion Sensor will always trip the alarm when it sees motion. When the system is armed using an SH624 Remote Control it can be armed in the Home or Away mode. Place the Motion Sensor on a bookshelf, or attach it to a wall about 6 feet off the ground, using the supplied mounting bracket. [. . . ] For help or more information on setup, please visit: www. x10. com/support MS10A-8/02 X10. com, a Div. [. . . ]