User manual X10 VR31A

[. . . ] · Plug the equipment into an outlet on a different electrical circuit from the radio/TV experiencing the interference. · If necessary, consult your local Dealer for additional suggestions. CH A N N EL A BC D ON-OFF Switch (on side) Power Supply Jack A/V Jacks TV C H A N N EL TV Channel Switch 34 NOTE: Modifications to this product will void the user's authority to operate this equipment. 2. 4 GHz Channel Switch 2 3 CONNECTING UP 1. Connect a set of Audio/Video cables to the A/V OUT jacks on the Audio/Video Receiver. [. . . ] For single camera systems the power supply for the Camera will normally be on (it powers up on). For Multi-Camera systems you need to purchase a TM751 Transceiver for the remote control to be able to turn Cameras on. When you turn any one on, in a group of 4 on, the others in the group turn off. Check that all camera power supplies are set to the same Housecode as the Transceiver and remote control. If you are using the RCA jacks, make sure you are using the appropriate input mode for your TV, try pressing the A-B button or Video button on your TV's remote control to change the input mode (consult your TV's owner's manual, if necessary). If you are using the Coax cable, verify that the Receiver and the TV are on the same channel (3 or 4). If you connected the Receiver to a VCR and then connected the VCR to your TV, you might need to turn the VCR OFF to see the Camera's picture on your TV. Or you might need to turn the VCR on, AND set it to record the picture from the Camera, in order to see the picture on your TV. Or you might need to press the A-B button on your VCR's remote control. If you get a picture but the quality is poor: Try different positions for the antennas on the Camera and Receiver. Sometimes, due to reflections, you might get a better picture with the Receiver's antenna pointing to the ceiling. Take a look at what the video signal is passing through or near to get to the Receiver. Try to keep the Receiver as far away from other devices as the cables allow. In most cases, relocating the Camera or Receiver a few feet is enough to avoid the source of interference. Try unplugging/turning off any electromagnetic interference producing devices, such as a microwave oven, baby monitor, computer, wireless LAN, wireless speakers, cordless phone, cell phone, etc. Other 2. 4 GHz devices can distort the Camera's picture and/or cause buzzing in the audio. If you are experiencing interference between X10 Cameras and some other equipment that uses 2. 4 GHz, check the other device's owner's manual for the frequencies of each channel that it uses. X10 cameras use the following frequencies: Channel A: 2. 411 GHz, Chan B: 2. 434 GHz, Chan C: 2. 453 GHz, Chan D: 2. 473 GHz. [. . . ] (X10) WARRANTS ITS PRODUCTS TO BE FREE FROM DEFECTIVE MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. X10 AGREES TO REPAIR OR REPLACE, AT ITS SOLE DISCRETION, A DEFECTIVE X10 PRODUCT IF RETURNED TO X10 WITHIN THE WARRANTY PERIOD AND WITH PROOF OF PURCHASE. CALL 1-800-675-3044, OR VISIT WWW. X10. COM, OR E-MAIL SALES@X10. COM TO OBTAIN A RETURN MERCHANDISE AUTHORIZATION (RMA) NUMBER. [. . . ]