User manual X10 WS12A

[. . . ] Single & 3-Way Decorator Wall Dimmer Set Up and Operating Instructions WS12A/WS14A Traveller wires Cap off with wire nut A WS12A B WS12A Master WS14A Companion The WS12A Wall Dimmer Module is designed to control incandescent loads with a rating of between 40W and 500W. The switch can replace a single switch that controls a ceiling light or outside light. [. . . ] Make sure no bare whiskers of wire are protruding, use insulating tape to cover wire nuts if necessary. Installing the Wall Dimmer Module (3-way applications, diagram B) · Disconnect the power at the circuit breaker panel. · Remove wall plates and unscrew the existing switches from their boxes. Identify the common wire at each existing switch (usually connected to a different color terminal). · Replace one of the existing wall switches with the WS12A Wall Dimmer (Master): connect the common wire to the blue wire on the WS12A using a wire nut. Connect the two remaining "traveller wires" to the red and black wires on the WS12A, using wire nuts. If one of the travellers is red connect it to the red wire on the WS12A. · Replace the other existing wall switch with the WS14A Companion Switch (sold separately): connect the common wire to one of the WS14A's terminals labelled LIVE. Connect the traveller which you connected to the red wire on the WS12A to the terminal labelled SWITCH on the WS14A. Connect the remaining traveller wire to the second terminal labelled LIVE on the WS14A. Setting up and operating the Wall Dimmer Module · Pop the rocker paddle off the WS12A (using a small screwdriver). Set the House Code dial to the same letter (A thru P) that you set on your X10 controller(s). [. . . ] X10 agrees to repair or replace, at it's sole discretion, a defective X10 product if returned to X10 within the warranty period and with proof of purchase. If service is required under this warranty: Call 1-800-442-5065, visit www. x10. com, or e-mail sales@x10. com. X10. com, a division of X10 Wireless Technology, Inc. [. . . ]