User manual ZIBRO D8

[. . . ] the mobile Zibro Clima dehumidifier is extremely easy to operate and move. You have acquired a high quality product that will provide you with many years of pleasure, on condition that you use it responsibly. Reading these instructions for use before operating your Zibro Clima will optimise its life span. Customer service department This appliance must be earthed and should only be connected to an earthed 230 V/50 Hz mains. [. . . ] For this reason, the dehumidifier should be positioned in a central and clear location so that it can draw this moist air from all over the home. a warm hallway or landing is an excellent position for your dehumidifier. Alternatively, if you have a serious problem in one area you can begin by positioning the dehumidifier close to this area and later moving it to a more central point. For the most efficient use, outside doors and windows should be kept closed when the dehumidifier is operating. When positioning your Zibro Clima dehumidifier, ensure that it is placed on a level surface clear of any obstacle that may limit the air movement. If you move the unit, it should first be switched off and the water tank emptied. The unit is switched off by turning the knob all the way anticlockwise. When a comfortable level of humidity is reached, turn the knob slowly anti-clockwise until the unit switches off. The dehumidifier will now automatically maintain the humidity at this level. When the unit is switched on, the fan will start running in low speed. WATER FULL indicator When the water container is full, the WATER FULL indicator light will illuminate and the unit will automatically shut off. The WATER FULL indicator light will also illuminate and the unit will beep if the water container has not been properly inserted or if it has been removed. When the water container is full the WATER FULL indicator light (I) will illuminate and the unit will automatically shut off. Wait a few minutes to allow the water to finish draining into the water container. To remove the water container, disconnect from the mains, pull out and lift the water container by the handle and carry it away for emptying. When the tank is properly inserted, both the hole and the float mechanism in the container will be located directly beneath the drainage spout and the WATER FULL indicator light(I) will go out. It may be more convenient to set up the dehumidifier for continuous drainage with the following procedure: · Remove the water container from the unit; Click the supplied spout (the long end depressing the microswitch) firmly in place; Place an appropriately sized drainage pipe over the spout inside the housing; Place the other end of the pipe in a drain, ensuring that: - it Is not twisted, folded, or otherwise likely to obstruct the water flow, - the spout is not under the water level of the drain; · There must be a gradual downward slope from the spout to the drain. In very cold weather conditions precautions should be taken to prevent the drainage pipe from freezing. To return to water container use, take the spout out and replace the water container. Clean regularly with a common, non abrasive, household detergent, without solvents. [. . . ] 4 Components subject to normal wear, such as the filter, are not covered by the guarantee. 5 The guarantee is valid only when you present the original, dated purchase invoice and if no modifications have been made. 6 The guarantee is invalid for damage caused by neglect or by actions that deviate from those in this instruction booklet. 7 Transportation costs and the risks involved during the transportation of the air conditioner or air conditioner components shall always be for the account of the purchaser. [. . . ]