User manual ZIBRO KRA106

[. . . ] For reasons of safety and to prevent soot build-up do not use the Zibro Kamin in a high wind. 5 metre from highly inflammable objects; take care when using the heater under awnings or canopies. Only use Class C1 paraffin fuel in accordance with BS2869 Part two, or equivalent. Your Zibro Kamin heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Plus. [. . . ] After having ignited the heater, always check whether the combustion chamber ¿ is level, by sliding it slightly to the left and the right by its handle (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes for the flame to become visible in the combustion chamber. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be adjusted with the wick adjuster knob · Too low a flame may also be caused by: (leave window or door ajar) (contact your dealer or replace the wick, refer to section M) Let the heater burn at its lowest setting (Fig. Then slowly turn the wick adjuster knob · counter-clockwise to its stop. NOTE: In case of an emergency, switch off the heater by turning the safety button counterclockwise (Fig. After a period of time the combustion may no longer be high enough (Section D). Follow the procedure below: 1 Release the automatic extinguisher by turning the safety button counterclockwise. 3 Take the plastic collar between your thumb and index finger and pull it out. 4 Carefully reinstall the wick adjuster knob · This can be done in one way only - check the rear of the cap for the correct position. If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If any malfunctioning cannot be solved from the directions below, please contact your Zibro Kamin dealer. After having refilled , wait for 30 minutes before igniting the heater. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). Reinstall the wick height lock (Section F) Before you refilled the tank, the heater had burnt up almost all the fuel. After having refilled, wait for 30 minutes before igniting the heater. Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). [. . . ] 10 Engage the automatic extinguisher by turning the safety button clockwise into vertical position. Turn the wick adjuster knob to be sure the wick moves smoothly up and down. NOTE: Remember always to start a new wick on position (1) of the wick height lock. NOTE: If the wick does not move smoothly and easily, or wick height on position (1) of the wick height lock is not in the range of 7-8 mm, do not use the heater. [. . . ]