User manual ZIBRO R17

[. . . ] For each model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section J). If a particular room is smaller than the specified space, always leave a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. In this way, the risk of harmful accidents at accidentally touching the top plate is considerably decreased. [. . . ] Apply more pressure you may turn it slightly further; however, it will automatically return to the startposition. Release the ignition button as soon as a flame is visible in the combustion chamber ¿. After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle ´ (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be slightly adjusted with the knurled wick adjustment knob · Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section L) Let the heater burn at its lowest setting (Fig. Then slowly turn the knurled wick adjustment knob · anti-clockwise to its stop. In case of an emergency, switch off the heater by pushing in the safety button ³ (Fig. If any malfunctioning cannot be solved from the directions below, please contact your dealer. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Before you refilled the tank, the heater had burnt up almost all the fuel. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). THE HEATER IS BURNING TOO HIGH You are using an incorrect, too volatile type of fuel. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). It is, however, important that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. Under normal conditions, only three components are subject to wear: Do not dispose of old batteries along with the other domestic waste. THE IGNITION COIL The ignition coil will have a longer life, if you ignite the heater in the correct manner. [. . . ] In order to avoid unnecessary costs, we recommend that you always read the 'Directions for Use' carefully first. In case they offer no solution, please take the heater to your dealer for repair. * Highly inflammable substances may induce uncontrollable burning, causing flames to break out. Should this happen, never try to move the heater, but always switch off the heater immediately (refer to Section E). [. . . ]