User manual ZIBRO R210C

[. . . ] Customer Service Department 1 READ THE DIRECTIONS FOR USE FIRST. 2 IN CASE OF ANY DOUBT, CONTACT YOUR DEALER. 3 BEFORE YOU START READING, FOLD OUT THE LAST PAGE. 4 50 GENERAL DIRECTIONS FOR USE Below you will find the main steps to be taken for using your heater. For more details, please refer to the MANUAL (pages 53 ff. ). MAIN COMPONENTS OFF Button Knurled wick adjustment knob 1 2 Remove all packaging materials (refer to Section A, Fig. Fill the removable tank and wait 30 minutes before you ignite the heater (refer to Section B, Fig. Ignition button Combustion chamber 3 Insert the batteries into the battery holder (refer to Section A, Fig. [. . . ] Never overfill the tank, especially not when the fuel is very cold (fuel expands when it heats up). 7 Let the remaining fuel in the pump flow back into the jerrycan and carefully I remove the pump. Close the lid. empty full C IGNITING THE HEATER A new heater may give off some smells for a short while, when it is used for the first time. You should therefore provide extra ventilation or ignite the heater outside the living room. When you use the heater for the first time, first put the filled removable tank into place, and then wait approximately 30 minutes before you ignite the heater. Follow the same procedure when you have completely burnt up all fuel from the tank, and after the glass fibre wick has been replaced. Before igniting the heater, always check the fuel indicator to see whether the removable tank needs filling up. Follow the procedure below: 1 Turn the knurled wick adjustment knob clockwise to its stop (Fig. If you J K apply more pressure you may turn it slightly further; however, it will automatically return to the startposition. When you have set the wick to its highest position, this action will automatically activate the safety device. Release the ignition button as soon as a flame is visible in the combustion chamber . Otherwise smoke or soot may be caused. G MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your dealer. THE HEATER DOES NOT IGNITE The batteries are not positioned correctly in the holder. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS The combustion chamber has not been positioned correctly. Use the handle to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Before you refilled the tank, the heater had burnt up almost all the fuel. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). 4 56 The room is insufficiently ventilated. Leave a window or a door wide open for a while. THE HEATER IS BURNING TOO HIGH You are using an incorrect, too volatile type of fuel. Follow the procedure on the next page: 1 Ignite the heater outside the living room and let it burn until all fuel is used. [. . . ] Position the front of the heater at a minimum distance of 1. 5 metres from walls, curtains, and furniture. Make sure that the fuel is not exposed to heat or extreme temperature changes. Always store the fuel in a cool, dry and dark place (sunlight will affect the quality). Never use the heater in places where harmful gasses or fumes may be present (e. g. [. . . ]