User manual ZIBRO R59C

[. . . ] We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your heater. In this way, the risk of harmful accidents at accidentally touching the top plate is considerably decreased. Only use Class C1 paraffin fuel in accordance with BS2869 Part two, or equivalent. [. . . ] When you use the heater for the first time, first put the filled removable tank into Place, and then wait approximately 30 minutes before you ignite the heater. Follow the same procedure when you have completely burnt up all fuel from the tank, and after the glass fibre wick has been replaced. Follow the procedure below: 1 Open the door at the front of the heater. 2 Slowly push down the igniter slide » together with the flame regulator · At the same time you will activate the safety device. 3 Release the ignition slide as soon as a flame is visible at the bottom of the combustion chamber ¿. After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle ´. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes for the flame to become visible in the upper end of the combustion chamber. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be adjusted continuously with the flame regulator · If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section F). Too low a flame may also be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (leave window or door ajar) (contact your dealer or replace the wick, refer to section M) Let the heater burn at its lowest setting for approximately one minute. In cases of emergency: switch off the heater with the safety device ³ (Fig. To do this, follow the next procedure: 1 Open the door at the front of the heater. 2 Slide up the wick height lock ¸ one step to position 2 or 3 (Fig. If this does not have the required effect, let the heater burn until all fuel is used (Section H). If the flame still remains too low after that and the wick is already set to position 3, contact your Zibro Kamin dealer, or replace the wick (Section M). If any malfunctioning cannot be solved from the directions below, please contact your Zibro Kamin dealer. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). Before you refilled the tank, the heater had burnt up almost all the fuel. [. . . ] 3 The warranty shall no longer apply, when the heater has been modified, non-original parts have been used, or when it is repaired by third parties. 4 The warranty shall not apply to parts that are subject to normal wear, such as the batteries, the ignition coil, the wick and the manual fuel pump. 5 The warranty shall only apply, when you present the original, dated proof of purchase, provided no changes have been made to it. 6 The warranty shall not apply to damages caused by actions not in compliance with the Directions for Use, neglect, and the use of an incorrect type of fuel, or fuel past its use-by date. [. . . ]