User manual ZIBRO RCA100

[. . . ] Your Zibro Kamin heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Plus. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Always refer to your local Zibro Kamin dealer for the right fuel for your heater. This cover allows you to keep your hands clean when opening the fuel tank. [. . . ] After approximately 10 seconds the blinking will stop and the setting will be locked. 5 Minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. F: When the CLOCK indicator light stops blinking, the setting has been locked to the indicated value. When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. Once the heater is burning, the The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. First press either of the two keys to switch on the function (the TEMP light next to the information display ¹ will start Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged for more than 10 minutes (or after a power failure), the temperature will reset to the factory setting of 20°C. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. Switch off the childproof lock by pressing the key and holding it down for more than 3 seconds once again. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped Switch off the function by pressing the SAVE key once again. Without the 'SAVE' setting your heater will maintain the set temperature by J: When the SAVE light lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. When the indicator light FUEL lights up, it means that there is only fuel left for 10 more minutes. The count-down of the remaining heating time can be seen in the information display ¹ (Fig. Now you have two options: you remove the fuel tank and refill it outside the living room (section B) or you push the button EXTENSION . by pushing this button , the remaining heating time will extend to 50 minutes. At the arrival of 10, you will hear an alarm signal every two minutes, warning you to refill the removable tank. [. . . ] Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: 1 We expressly dismiss all other claims for damages, including consequential damages. 2 Any repairs or replacements of components within the term of warranty will not result in an extension of the term of warranty. 3 The warranty shall no longer apply, when the heater has been modified, non-original parts have been used, or when it is repaired by third parties. [. . . ]