User manual ZIBRO SRE 160 TC

[. . . ] We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Do not use your Zibro in cellars or other underground areas. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your Zibro. THE RIGHT FUEL Only use Class C1 paraffin fuel in accordance with BS2869: Part 2, or equivalent. Your Zibro heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Extra or Zibro Kristal. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. [. . . ] 2 Use the adjustment keys to set the time at which the heater must ignite. Use the key on the left (Nhour) to set the hours and the key on the right set room temp. 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. H). 20:15 timer vent. fuel timer H: The TIMER indicator light indicates that the timer function has been switched on. 4 The timer will ensure that the room will have been heated to approximately the required temperature at the set time. G H hour min. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the button once to clear the timer setting. key-lock SWITCHING OFF THE HEATER There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). THE INFORMATION DISPLAY The information display not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: set room p. ck e- 0 timer vent. fuel CODE INFORMATION Temperature within the heater too high. Contact your dealer. In case of any malfunctioning the information display will tell you what is the matter. hour min. efef key-lock- 0 0 1 1 4 47 eeee- 2 5 6 7 Starting problems. The heater has been in operation continuously for a period of 65 hours and has turned itself off automatically. Contact your dealer. Clean filter Contact your dealer. e- 8 e- 9 Switch the heater back on. Ventilate better. --blinking : -(& FUEL-light) Out of fuel. Too little ventilation. --blinking : -(& VENT-light) Always contact your Zibro dealer for any malfunctioning not listed above. set room p. k timer vent. AUTOMATIC DEACTIVATION This heater is fitted with a safety system that ensures that it switches off automatically after 65 hours continuous operation. If desired, you can switch the heater on again by pressing (see section D). k When the heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. The display will show the autocleaning code cl:05 running back to cl:01. The count-down of the remaining heating time can be seen in the information display (Fig. Every two minutes an alarm signal is 10 r vent. fuel sounded, warning you to refill the removable tank. The FUEL indicator light will blink, while four lines are blinking in the information display. Once the heater has used up all its fuel and extinguished, it will take some time, after the refill, before the heater is completely ready for use again. ur K: When the FUEL indicator light is lit, the information display will show the number of minutes of fuel left in the tank. min. key-lock set room . [. . . ] Always make sure that there is sufficient ventilation. 2 3 4 5 6 7 8 9 10 Defective electrical devices and batteries must be kept separate from household waste. Ask you local council or dealer for expert advice on recycling. 4 51 set room temp. clock save 20:15 timer vent. fuel save timer hour min. key-lock DISTRIBUTED IN EUROPE BY PVG INTERNATIONAL b. v. i STERREICH PVG Austria VertriebsgmbH Salaberg 49 3350 HAAG tel: +43 7434 44867 fax: +43 7434 44868 email: pvgaustria@zibro. com e BELGI PVG Belgium NV/SA Industrielaan 55 2900 SCHOTEN tel: +32 3 326 39 39 fax: +32 3 326 26 39 email: pvgbelgium@zibro. com q SCHWEIZ PVG Schweiz AG Salinenstrasse 63 4133 PRATTELN tel: +41 61 337 26 51 +41 61 337 26 78 fax: email: pvgint@zibro. com 2 DEUTSCHLAND PVG Deutschland GmbH Siemensstrasse 31 47533 KLEVE tel: 0800 - 9427646 fax: +31 (0)412 648 385 email: pvgdeutschland@zibro. com 6 DANMARK Appliance A/S Blovstroed Teglvaerksvej 3 DK-3450 ALLEROED tel: +45 70 205 701 fax: +45 70 208 701 email: appliance@appliance-group. com 5 ESPAA PVG Espaa S. A. San Jos de Valderas II Comunidad "La Alameda" C/ Aurora Boreal, 19 28918 LEGANS (Madrid) tel: +34 91 611 31 13 fax: +34 91 612 73 04 email: pvgspain@zibro. com 3 FRANCE PVG France SARL 4, Rue Jean Siblius B. P. [. . . ]