User manual ZIBRO SRE147

[. . . ] Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your heater. Only use Class C1 paraffin fuel in accordance with BS2869; Part 2, or equivalent. Your heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Extra or Zibro Kristal. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. [. . . ] After approximately 10 seconds the 4-digit will stop blinking and the setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the standby position. When the heater has been unplugged (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. ) to set the temperature to a switch on the function (the °C mark and 4-digit ¸ will start blinking). Next, adjust the temperature using the key on the right ( Higher setting and the key on the left ( After approximately 10 seconds the °C mark and 4-digit will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. J: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. The FUEL indicator will blink, while four lines are blinking in the information display. Once the heater has used up all its fuel and is extinguished it will take some time, after the refill, before the heater is completely ready for use again. When there is insufficient ventilation in the room, an intermittent buzzer will be heard (approximately once each ten minutes) and the VENT indicator will be lit. When this signal is given, ensure that the ventilation of the room is improved (e. K: A blinking VENT indicator is a sign that you need extra ventilation. Opening a door or window a little more), to avoid that the heater shuts off. When the ventilation of the room is improved, the VENT indicator and buzzer will be deactivated. When there is still insufficient ventilation, the heater shuts off automatically. when this occurs , e -1 1 is displayed and the VENT indicator is blinking. By opening a door or window a little more), the heater can be ignited by pushing the button ¹ again. [. . . ] 6 The warranty shall not apply to damages caused by actions not in compliance With the Directions for Use, neglect, and the use of an incorrect type of fuel, or fuel past its use-by date. In order to avoid unnecessary costs, we recommend that you always read the 'Directions for Use' carefully first. In case they offer no solution, please take the heater to your dealer for repair. * Highly inflammable substances may induce uncontrollable burning, causing flames to break out. [. . . ]