User manual ZONET ZFS3216E QUICK INSTALLATION GUIDE

[. . . ] 16/24 Ports Gigabit Switch ZFS3216E/ZFS3224E Quick Installation Guide Features Plug & Play Complies with IEEE802. 3, IEEE802. 3u, IEEE802. 3ab, IEEE802. 3x standards NWAY Auto-negotiation support, Auto-Sense the transmission speed, half/full duplex 16/24 ports 10/100/1000M Auto-Sense, Auto-MDI/MDIX Adopt IEEE802. 3x flow control for full-duplex and backpressure for half-duplex Store and forward structure MAC address auto learning Support IEEE802. 3x for broadcasting storm control Package Contents One 16/24 Ports Gigabit Switch One Quick Installation Guide One Power Adapter Four rubber pads Two L-shape rackmount brackets and screws Front Panel LED lights panel Rear Panel AC power line socket and power switch Side Panel Ventilation and cooling holes Please make sure there are no substances blocking up these holes, and leave enough space on both sides of the switch, so the switch can have proper ventilation and cooling to avoid over heat inside the unit, which may cause damages and/or system malfunctions. LED Power 10/100M Link Status Operation Green Steady: Power is ON Steady: Indicates a 10/100M device is connected Green Flash: the port is transmitting/receiving data Off: Indicates either a 10M device or no device connected Steady: Indicates this port is working under full duplex mode Full Duplex Green Flash: Indicates there is data collision at this port (FDX/COL) Off: Indicates this port is working under half duplex mode Steady: Indicates a Gigabit device is connected 1000M Link/Act Green Flash: the port is transmitting/receiving data Off: Indicates either a 10/100M device or no device connected Front Panel Diagrams ZFS3216E(top) / ZFS3224E(bottom) Installation 1. [. . . ] Install all four(4) rubber pads at the bottom corners of the switch to avoid scratch at the bottom surface. When installs it on the rack, make sure to fix tight it on the rack with the screw. Maximum cable distance between the Switch and other IEEE802. 3 compatible network devices is 100 meters Only Category 3/4/5 cables can be used in 10 Mbps operation mode. Must use an Unshielded/Shielded Twisted-Pair (UTP/STP) Category 5 cable or higher Grade data cables in order to operate 100Mbps and 1000Mbps network operations. May experience loss of data packets when Category 3 or 4 cables are used. Auto-MDIX ports allow all kinds of IEEE802. 3 compatible network devices, such as hub, switch and computers, to connect to the Switch using straight-through wires and/or crossover cables. Troubleshooting We always do our best to deliver high quality products to our customers; however, problems may still occur when using the product. Many problems are due to disconnected cables, faulty cables, exceeded maximum cable length, or malfunctioning NIC. [. . . ] Notice: If problem still persists and cannot be solved, write down your software/hardware configuration and error indications from LEDs and call your local retailer or the store purchased for further assistance. If the Power LED is not ON, check [. . . ]